Honda-SOHC
Other Stuff => Misc / Open => Topic started by: Athame57 on September 27, 2020, 03:56:01 PM
-
I nearly blew a fuse but perforated a thumb a few times instead. :o This was me struggling to sew two badges onto my leather jacket sleeves. Apart from needing a wooden beer mat and my nail clippers to get the needle through I found aiming the needle from inside the sleeve a bit like that blind fold game of pinning the tail on the donkey. Is there a proper way of going about this?.....Julie? ;D
-
I nearly blew a fuse but perforated a thumb a few times instead. :o This was me struggling to sew two badges onto my leather jacket sleeves. Apart from needing a wooden beer mat and my nail clippers to get the needle through I found aiming the needle from inside the sleeve a bit like that blind fold game of pinning the tail on the donkey. Is there a proper way of going about this?.....Julie? ;D
I used to stick mine on with glue and just put a stitch at each corner to make sure it never fell off ;D ;D ;D. I tried sewing on a Triumph patch once, never again ;D ;D ;D
-
I used to stick mine on with glue and just put a stitch at each corner to make sure it never fell off ;D ;D ;D. I tried sewing on a Triumph patch once, never again ;D ;D ;D
This is what I ended up doing. You know those sticky leather patches you can get on ebay for patching sofas et al ? I sewed the badges onto them and cut around the edges with scissors because they are thinner and you can see what you are doing, and stick them on, however I quickly discovered they need support as you have done by corner stitching, alas, that was enough of a challenge to have me ask on here!