1
CB500/550 / Generator electrical cabling grommet
« on: January 28, 2021, 06:16:12 PM »
Are there any workaround or suggestions to repairing/replacing the plastic/rubber grommet items as shown below. The one on the left is so damaged and old that pieces are just falling off each time a touch it.
My current thought is to get plastic pieces 3d printed and creating an new cabling run for stator, coil, oil, neutral, etc which would be routed through these printed pieces and then epoxy to seal.
All suggestions and comments welcomed here
My current thought is to get plastic pieces 3d printed and creating an new cabling run for stator, coil, oil, neutral, etc which would be routed through these printed pieces and then epoxy to seal.
All suggestions and comments welcomed here