Honda-SOHC
SOHC.co.uk Forums => CB750 => Topic started by: legin101 on June 03, 2020, 04:23:04 PM
-
Hi guys who would you recommend for a new clutch for a f2
cheers
nigel
-
As in parts manufacture do you mean?
Or who to fit it?
-
No who to buy one from ive searched all over the place, when i search it keeps bringing up later models due to the f2, is it the same clutch as the K models.
-
No who to buy one from ive searched all over the place, when i search it keeps bringing up later models due to the f2, is it the same clutch as the K models.
Personally, I have no idea about F2 Clutches but have you looked at EBC clutch list?
https://bikes.ebcbrakeshop.co.uk/honda_c275691_277054.htm
-
It's on their list, 8th line down.
[attachimg=1]
[attachimg=2]
-
Thank you very much, its on order quick as that
nigel
-
Be carefull when doing the lifter plate up I just chipped mine. :(
-
Be carefull when doing the lifter plate up I just chipped mine. :(
That was a silly thing to do young Mick 🙄🙄🙄🙄
-
As you know its all to easy too do.
Do you think I can get away with using it?
-
As you know its all to easy to do.
Do you think I can get away with using it?
If it's only a corner that has chipped off, yes, it'll be fine but if its cracked through the hole, no.
-
Bummer its just into the hole.
-
Bummer its just into the hole.
😭😭😭😭
-
Thats the answer I expected but didn't want to hear.
Sods law states I will buy another and snap that too.
-
This may be an option Mick - https://good-bits.co.uk/product/cb750-sohc-clutch-actuating-hub/
-
I wasn't aware of the problem so many thanks i will try not to do the same.
-
I cracked the corner off the lifter plate, just into bolt hole, it seems to function ok. What is the potential damage if not replaced?
-
now i have seen this infamous plate i can see why it happens, if the tension is taken off by all bolts at the same time then it will not break likewise when refitting take the tension by all bolts at the same time, now 3 bolt holes in good condition i would use a washer over the remaining hole and tighten to the specific torque. that should be fine.
-
Forget torque just snug by hand
-
I ordered the lifter plate from Goodbits on the 5th June and it arrived on the 8th so great service.
I have finally got around to fitting it today after work. I would go out on it to test my new clutch but I'v hurt my shoulder and can't twist the throttle :'(