Honda-SOHC

SOHC.co.uk Forums => CB500/550 => Topic started by: philward on December 15, 2020, 10:49:22 PM

Title: CB500K2 - Is this part available?
Post by: philward on December 15, 2020, 10:49:22 PM

Is the rubber/plastic link shown on the right in the CMSL schematic in the link below (only available as part of 'holder set' at CMSL).
Mine are brittle/split at the holes - are they available? Are they essential - can't figure out what they do really.
https://www.cmsnl.com/honda-cb500k2-general-export_model50441/holder-set-b-adj_16030323004/#.X9k6Xtj7TIU

Title: Re: CB500K2 - Is this part available?
Post by: Nurse Julie on December 15, 2020, 11:03:49 PM

They keep the shite out of the mechanism Phil. There is a chap in Australia that was making them, a small fortune though.

Title: Re: CB500K2 - Is this part available?
Post by: philward on December 15, 2020, 11:11:14 PM

Thanks Julie - I'll glue some o rings to them   were they've split I think

Sent from my moto g(7) power using Tapatalk

Title: Re: CB500K2 - Is this part available?
Post by: Nurse Julie on December 16, 2020, 08:43:45 AM

Quote from: philward on December 15, 2020, 11:11:14 PM

Thanks Julie - I'll glue some o rings to them   were they've split I think

Sent from my moto g(7) power using Tapatalk

If you haven't got any bits of the plastic missing Phil, a drop of Superglue sticks the ends together a treat.

Title: Re: CB500K2 - Is this part available?
Post by: philward on December 16, 2020, 08:48:11 AM

I'll give it a go - thanks

Sent from my moto g(7) power using Tapatalk