Honda-SOHC
SOHC.co.uk Forums => CB350/400 => Topic started by: 4wDaz on May 17, 2020, 08:12:24 PM
-
Hi, Just about to start rebuilding the carbs, does anybody know what size the o rings are for the Tee where the fuel pipe goes on ? Thanks
-
6x2 rings a bell but get someone else to confirm.
-
I used 2mm cross section x 5.5mm Viton on mine with no leaks.
Readily available on eBay.
The four rings for the metal fuel inlet tee piece are not included when you get a full set of Keyster kits as I found out recently.
-
6x2 Viton.
-
Thanks for the replies, i found some orings which came with the bike which are 1.9mm x 5.8mm in a honda bag which i thought could have been what i needed