31
CB500/550 / Re: 500 K cafe racer conversion - build thread
« on: June 15, 2014, 06:33:51 PM »There is a steel bracket that the alloy end caps screw to, this is held by a 6mm (10mm spanner) bolt that needs a soft alloy washer between the bracket and the cam cover to stop oil leaking. If this was not fitted or replaced with a steel washer you frequently get a bad oil leak
cheers Bryan, can confirm that alloy washers are present on both sides. Took it for another run... bit of front end twitchiness kicking in at 90mph on the country roads .. need to think about swopping the yolks over to NSR125 ones to reduce offset and increase trail I think