This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Golfcarmad
16
« on: May 09, 2020, 02:45:55 PM »
Thanks for advice. New indicators are 10w bulbeds (not LED). Pulled all my lovely wiring apart and connected 21w indicators to right hand side- No difference-still no flashing. I don’t think I need to connect all 4. Confident new relay works fine as fellow forum member sent it to me after checking it works. So where next??
17
« on: May 09, 2020, 12:33:02 PM »
Hello everyone. Well the 400 is finally finished. Starts on the button-sounds awesome. Only problem now is indicators don’t flash-they come on-front and rear and console. Relay clicks once-but no flashing. Every other lightetc works perfect. Relay swapped for working item-still no wink wink. Open to suggestions please? Thanks Paul
18
« on: May 06, 2020, 11:07:56 PM »
Could be forks off cb400n-I have forks off cb250n on mine.
19
« on: May 06, 2020, 05:27:36 PM »
Not sure if my solution helps-but it was cheap and has worked: A right mess of camshaft tensioner thread on outer casing. So I tapped a new thread M8 dropped a ball bearing in crewed in bolt with lock nut-So now it’s more a manual adjustment but worked fine. Hope this idea helps-you have nothing to lose trying it before you spend hundreds/new cases.
20
« on: May 06, 2020, 05:19:00 PM »
Julie-never knew you had an eBay page.
21
« on: May 02, 2020, 07:29:26 PM »
Hi Max,I wrote a reply with details you asked for,it will not send as no email address for you. Mine is pauliskelly@hotmail.com Thanks again your a star
22
« on: May 02, 2020, 02:20:51 PM »
It is a 250N front end-all sorted now-thanks for help n advice
23
« on: May 02, 2020, 01:01:31 PM »
I have just had same problem after complete rebuild. So I took carbs out-and cleaned everything again meticulously. In my opinion when springs inside move a little sideways-this causes the issue. Mine are fine now-just clean them and be gentle putting bowls back on.
24
« on: May 02, 2020, 12:51:38 PM »
Please can I have it-sorry for delay. Regards Paul
25
« on: April 23, 2020, 09:57:47 PM »
Thanks-will give it a try.
26
« on: April 23, 2020, 08:35:49 PM »
Mine is the round one with 3 pins.
27
« on: April 23, 2020, 07:25:36 PM »
Hi guys n gals,do anyone know of an alternative indicator relay to the DS £30 part?
28
« on: April 13, 2020, 04:04:13 PM »
Thanks-yes comstars fitted so will look at super dream.cheers Paul
29
« on: April 13, 2020, 03:41:16 PM »
The attached photo shows the front brake system that came with my 400/4. Looking for schematic of it-but it is not same as type in Haynes. Can anyone suggest what Honda it is from? Thanks Paul
30
« on: April 26, 2019, 02:58:07 PM »
Froze mine.went in easy after that.
|