This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Pmd31421
Pages: [1]
1
« on: January 29, 2018, 07:34:11 PM »
Hi just tried the clutch arm .i can’t move it more than 5 or 6mm by hand , although it seems to pull up ok by the clutch lever . Also it’s a right handed thread on the adjuster.
2
« on: January 29, 2018, 07:03:25 PM »
Hi I tried the clutch arm on the side cover , but it’s almost too stiff to move by hand . It moves about 6mm . It moves ok when using the clutch lever tho.
3
« on: January 28, 2018, 10:00:28 PM »
I’ll check tomorrow and let you know if ok
4
« on: January 28, 2018, 09:21:39 PM »
The Haynes manual doesn’t say how to adjust so I adjusted the way I’ve always done other clutches . Eg wind in until meets resistance then back off 1/4 turn . Not sure that is the right way .
5
« on: January 28, 2018, 05:42:23 PM »
Yeah I def fitted that part .
6
« on: January 28, 2018, 04:27:18 PM »
I take it your talking about the little tube piece with the spring inside ? I fitted that piece.
7
« on: January 28, 2018, 04:17:43 PM »
Not sure if it was working as I never had it running
8
« on: January 28, 2018, 04:16:31 PM »
Hi yeah there’s feel at clutch lever . When I adjust the adjuster it meets resistance and I back off 1/4 turn . When I pull lever in the drive is maintained to real wheel it doesn’t make any difference. As far as I know I didn’t see it fall out .
9
« on: January 28, 2018, 03:49:00 PM »
Hi , I mean when you pull clutch in there is still drive to wheel .
10
« on: January 28, 2018, 11:15:32 AM »
Hi just restored my Honda SS50. Rebuilt the clutch ( it’s the single plate type) with new plates . Cleaned and inspected it and put back together , with all the parts.
However it won’t engage , no matter how I adjust it . Advice ?
11
« on: July 09, 2017, 09:17:12 PM »
Hi def not the earths . I ran individual cables back to the battery - .pole.
However the taillight is now working , even tho the stubborn headlight still won't have none of it .
I didn't realise bike had to be running for lights , even tho it's not made any difference .
Check the charging voltage at battery with engine running ..... approx 6.57 volts .
12
« on: July 08, 2017, 08:48:59 AM »
Hi , going to check all the earths . Indicators light up but just stay on they don't flash , even with motor running . Headlight .....nothing front or back , although brake light works . Check bulbs they all ok ..
13
« on: July 06, 2017, 09:32:36 PM »
Battery output is 6.5 volts.
I've just had the frame plastic coated
14
« on: July 06, 2017, 11:13:52 AM »
Hi , I'm only getting 4.5v at my indicators and nothing at my headlight . It's got a brand new battery and the horn works fine . Running out of ideas ?
Pete
Pages: [1]
|
Show Posts