1
CB500/550 / Fork I.D help
« on: May 19, 2021, 03:05:53 PM »
Helloooo
I've started to pull apart this 550/4 chop and have come to the forks, which are longer than standard. They could be off the 750 but not sure. I've been thwarted by an aftermarket headlight rubber tube that's stuck to the stanchion and which I think will have to be cut off. I've undone the bottom of the fork leg and there's no bushes evident on the stanchion and the seal is proper wedged into the leg. I've undone the top and extracted the spring, which was upside down and appears covered in old crust. The stanchion is 35mm Diameter, the old seal is 8.5mm deep. There's a little bit of wear on the chrome in the travel and the other leg has bit of surface rust. How do I I.d these forks please? Do you need a pic, measurements... your help would be greatly appreciated.
Another consideration would be to change them for another set of forks, what others are similar/will fit please? Cheers
I've started to pull apart this 550/4 chop and have come to the forks, which are longer than standard. They could be off the 750 but not sure. I've been thwarted by an aftermarket headlight rubber tube that's stuck to the stanchion and which I think will have to be cut off. I've undone the bottom of the fork leg and there's no bushes evident on the stanchion and the seal is proper wedged into the leg. I've undone the top and extracted the spring, which was upside down and appears covered in old crust. The stanchion is 35mm Diameter, the old seal is 8.5mm deep. There's a little bit of wear on the chrome in the travel and the other leg has bit of surface rust. How do I I.d these forks please? Do you need a pic, measurements... your help would be greatly appreciated.
Another consideration would be to change them for another set of forks, what others are similar/will fit please? Cheers