This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Topics - Popstar
Pages: [1]
1
« on: November 29, 2021, 05:03:53 PM »
The plate on the headstock of my bike has 6/71 on it does that make it a KO or K1 ?
2
« on: November 21, 2021, 01:08:14 PM »
When reassembling the front end is it quicker to put the mudguard in first or the wheel in first ?
3
« on: November 11, 2021, 08:49:48 PM »
Does any forum member have a front black disc shroud for sale.thanks in advance. .
4
« on: November 07, 2021, 05:25:43 PM »
Would forum members please be good enough to checkout to photos I have attached to this thread. I am interested in service limits and plate quantities, I have purchased a new clutch cable as the one fitted took two hands to pull in,however when I inspected it no snagging was evident, does this early model have a paticular issue with the clutch?
5
« on: November 01, 2021, 01:01:23 PM »
I've discovered why the clutch isn't working on my project bike 1 the cable looks like it's been under artillery fire, 2 a small collar is missing where(see photo) the ball bearing sit's. I will have to see if Silvers have a pair. There is a rim on the outer edge which would be difficult to match.
6
« on: October 29, 2021, 01:01:47 PM »
Has anyone got a pair of working condensers for a 500 k1 that they would like to sell? £25 ish for a pair on line.
7
« on: October 27, 2021, 03:10:14 PM »
Hello I’m just about to strip my 71 advance and retard mechanism and I’ve noted that there is an index mark on the outside of the central cam,Should the index mark lineup with the timing mark(hole) indicated by the Biro pen on the right hand side of the plate or as close to it as possible, also does anyone notice anything out of the ordinary on this advance and retard unit it is the number 323 which I believe is correct for the 71 model.
8
« on: October 26, 2021, 08:34:46 PM »
After assembly of my carbs from a box of bits I've discovered two vent pipes , the longer one comes out of the vent on the cam box which is very long and would fit on the offset tube appature on the air box, the other pipe has a larger diameter pipe and is sleeved down to a smaller diameter pipe but doesn't appear to have anywhere to live. The bikes is a 71 500k1
9
« on: October 20, 2021, 05:20:49 PM »
Hello everyone, it's my first post and I'm after carb bowl (brass) drain screw if anyone has one, I've had to drill one out. It's a fine thread . I hope the attachment photo works.
Pages: [1]
|
Show Posts