Honda-SOHC
SOHC.co.uk Forums => CB750 => Topic started by: Paulreade on September 04, 2018, 08:17:24 AM
-
2 questions:
1. Refitting the spindle clamps am I right in thinking you fit them with the 'f' mark to the front , slightly thicker side, and clamp this up tight, then tighten the rear bolt to clamp the spindle. I cannot find the torque settings does anyone know what they are, it appears to be an8mm bolt ? Would around 18 lb ft be ok ?
2. Anyone know of a party that might offer an opinion or actually 're true' spoke wheels in the stockport/ high peak areas ?
Cheers
Paul
-
Attched pic is from K7 service manual, shall be the same for all 750K I suppose
(https://uploads.tapatalk-cdn.com/20180904/fe8afbc65fc0fe05bc998e91d2277fb1.jpg)
-
Cheers erny, that's great.
-
That's usefull info'
-
Manchester extreme on the A6 respoked my dt175mx.
-
Interesting - how much did they charge ?
-
Was about £140 in stainless iirc
-
I assume that was for 2 wheels ?
-
Yes both done. Was a while ago