Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Dodgy

Pages: [1]
1
Interchangeability / Re: CB250N Comstars
« on: August 28, 2011, 11:56:54 PM »
You can use the front from a superdream but you have to use a cb650 rear as the hub wider to suit a 4cylinder engine and should go straight on with just modifying some spacers.

2
CB500/550 / Re: need help on the how the footpeg and brake pedal fit together CB550 k
« on: August 28, 2011, 11:29:00 PM »
Go here and you will be able to see the parts diagrams may help http://www.cmsnl.com/cb550k3-four-england_model14671/partslist/?q=cb550

3
CB500/550 / Spacers to fit comstars to CB550
« on: October 16, 2010, 11:21:21 AM »
Does anyone know the correct size of spacers I need to fit so the wheels are centerd properly. I am trying to fit 19" superdream comstar to cb550 forks using cb550 spindle, also fitting cb650 comstar to cb550f swinging arm, if someone has done this already which Im sure you have can you let me know the spacers required?

4
Misc / Open / Re: Rod Gibson has Died?
« on: August 18, 2009, 10:46:08 PM »
Yes it is true and his z1 is up for auction at the stafford show being auctioned by bohnams.

5
CB500/550 / 605cc head gasket
« on: August 10, 2009, 11:36:07 PM »
Does anyone know where i can get a 605cc big bore head gasket?

6
CB500/550 / Re: Swing Arm Fitment
« on: February 13, 2009, 10:22:07 PM »
It wont be minted but will be ok I think building on a budget and spent too much already :) . I have had it a while and started rebuild as chop will post some pics of unfinished chop rebuild if I can find them. Got some bits from the USA before the pound dollar exchange went tits up. Found some pics

   

7
CB500/550 / Re: Swing Arm Fitment
« on: February 12, 2009, 10:15:53 PM »
Quote from: Bryanj on February 12, 2009, 09:57:09 AM
is that a UK K3 or a us K1/2

Im assuming its a uk k3, bought the frame on fleabay as the other one I have has been butchered to make a chop. I am trying to build a standard looking 550 from this. Paid 37 quid for it. Was going to keep it as a chop but decided standard would be better. Will post picture of it half renovated as a chop before i decided to go the standard route :)


8
CB500/550 / Swing Arm Fitment
« on: February 11, 2009, 06:47:11 PM »
What swing arm can I fit to my 550k frame, I have a 750 sohc drumbrake model arm will this fit ok, has anyone done this or something similar?

9
New Member Introductions / Another hello from Scotland
« on: February 11, 2009, 12:39:32 AM »
Hi I live near Glasgow and have two project cb550 on the go, trying to make possibly one good from two rats, will post some pics etc. as I go along. And hoping to pic loads of brains on the way.

Pages: [1]
SimplePortal 2.3.5 © 2008-2012, SimplePortal