Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Aspro

Pages: [1]
1
CB750 / Re: 341 repo exhaust fitting issues.
« on: May 10, 2019, 08:18:56 PM »
I had the same problem with a set I bought for my K2 from DS, they went back and were returned with the advice they now fitted however they were still a struggle.
I was looking at the headers on the pipes last week and spotted bubbling on the chrome. Informed DS and they offered a full refund when returned, where do I now buy a set with confidence.

2
CB750 / Re: K1 engine crankcases
« on: October 01, 2017, 12:09:23 PM »
Hi All

Thanks for the info, it seems like the biggest problem is getting them clean enough to respray. I had them dipped however I will go over them by hand myself, then try some of the cleaning techniques Trigger uses, one other question if anyone is still following this link is the lower case has a very rough finish to the casting should I file or grind this down or leave as is.

3
CB750 / K1 engine crankcases
« on: September 29, 2017, 09:10:32 AM »
Hi All

Fairly new to this however here goes, just had my engine cases etc. stripped and would like to know what the correct colour is to respray them. I also read recently that the cases were originally sprayed with a finish coat directly onto the bare ally, can any confirm.

4
CB750 / Re: stripping and painting crankcases
« on: September 21, 2016, 07:05:57 PM »
I was just about to have my cases vapour blasted, having read these posts perhaps I will go down the acid stripping line. Any advice on spraying the cases and barrel etc. would be appreciated. :D

Pages: [1]
SimplePortal 2.3.5 © 2008-2012, SimplePortal