21
CB350/400 / Re: Transmission output shaft bearing removal
« Last post by Dolomite_ on May 26, 2024, 07:13:49 PM »The shop manual doesnt show a seal between the collar and bearing/bearing and sprocket.
Try our new info resource - "Aladdin's Cave" (Main menu)
Just added a separate link to Ash's Dropbox thread (shortcut)
21
CB350/400 / Re: Transmission output shaft bearing removal« Last post by Dolomite_ on May 26, 2024, 07:13:49 PM »The shop manual doesnt show a seal between the collar and bearing/bearing and sprocket.
22
CB500/550 / Re: Starter solenoid« Last post by Neill C on May 26, 2024, 07:00:20 PM »Thanks. The joys of owning a 47 year old bike are never ending!
23
CB500/550 / Re: Headlight reflector« Last post by Johnwebley on May 26, 2024, 06:58:21 PM »I don't know the answer,
But I have a H4 bulb,in a non standard reflector, Fitting Cebie or similar used to be an upgrade Sent from my SM-A546E using Tapatalk 24
CB500/550 / Re: Headlight reflector« Last post by DomP on May 26, 2024, 06:53:29 PM »I was more wondering I could retain this reflector but retro fit an H4 led Ted
25
CB350/400 / Re: Transmission output shaft bearing removal« Last post by McCabe-Thiele (Ted) on May 26, 2024, 06:48:58 PM »Might be worth a PM to Laverda Dave he did a 400 gearbox rebuild earlier this year.
26
CB350/400 / Re: Transmission output shaft bearing removal« Last post by Dolomite_ on May 26, 2024, 06:44:22 PM »If you mean the part of the shaft where the oil seal sits I'm pretty sure the bearing will come off - just dont heat it and destroy the O ring. Ill have to dig my vice out from the garage. I didn't think of clamping the bearing. I didn't want to damage it too much but I think that's the only way. 27
CB350/400 / Re: Transmission output shaft bearing removal« Last post by McCabe-Thiele (Ted) on May 26, 2024, 06:39:58 PM »If you mean the part of the shaft where the oil seal sits I'm pretty sure the bearing will come off - just dont heat it and destroy the O ring.
28
CB500/550 / Re: Headlight reflector« Last post by McCabe-Thiele (Ted) on May 26, 2024, 06:36:06 PM »My 500 headlamp is a standard UK style 7" unit.
It has the three lugs similar to those on the old sealed beam headlights. I fitted a Land Rover Defender 90 type LED headlamp unit but pretty much any old style 7" headlamp will fit. 29
CB350/400 / Re: Transmission output shaft bearing removal« Last post by Dolomite_ on May 26, 2024, 06:34:50 PM »How to remove the output bearing. I've added the picture, it didn't work at first. I don't think the bearing first over the collar? The collar seems to be bigger than the bearing. Its the collar that I cant seem to remove. I've not tried heating it up yet, I'm going to try later. 30
CB350/400 / Re: Transmission output shaft bearing removal« Last post by McCabe-Thiele (Ted) on May 26, 2024, 06:29:23 PM »Iirc there is an O ring between that collar and the gears so heat would ruin that.
|