1
Member 4 Sales / Re: 76 cb550f
« on: April 06, 2022, 04:52:25 PM »
Photos, can get more if required
Try our new info resource - "Aladdin's Cave" (Main menu)
Just added a separate link to Ash's Dropbox thread (shortcut)
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1] 2
1
Member 4 Sales / Re: 76 cb550f« on: April 06, 2022, 04:52:25 PM »
Photos, can get more if required
2
Member 4 Sales / 76 cb550f« on: April 06, 2022, 04:46:59 PM »
Hi guys due to separation need to get the bike gone. She's a 76 cb550f runs but needs going over. She has a 78 valve cover fitted, cb650 cam and tacho drive,cb750 clocks and a dyna s ignition and coils. Really don't know what she's worth just need her out of the ex's garage. Bike is based in Bristol. Any questions fire away, cheers Gordon
3
CB500/550 / Re: Top end o rings« on: May 25, 2018, 12:10:14 PM »
Cheers Julie will drop you a list once I've deciphered cmsnl diagrams.
4
CB500/550 / Top end o rings« on: May 25, 2018, 10:37:30 AM »
Hi guys
Anyone know where is best to purchase just the required O rings for a Top end rebuild of a cb550 without the gaskets. Cheers Gordon 5
CB750 / Re: Starting tips« on: May 25, 2018, 10:34:00 AM »
With mine I do the following: fuel on, choke on, kill switch set to off, throttle full open, hit starter/kick start till oil light goes out, flip kill switch to run and hit starter/kick start with half throttle.
6
Misc / Open / Re: Tax and MOT 400/4« on: May 20, 2018, 09:30:01 AM »
Same as above 1976 550f just taxed little declaration done.
8
CB500/550 / Re: 550 K3 spark plugs« on: February 09, 2018, 10:53:32 AM »
Don't know how correct this is and I think ES plugs where replaced with EA.
http://oldmanhonda.com/MC/DataTable.html 9
CB500/550 / Re: 550 K3 spark plugs« on: February 08, 2018, 03:09:51 PM »
Ngk D7ea should do the job as has no resistor.
10
CB500/550 / Re: Kickstart starting (or not)« on: May 24, 2017, 08:34:12 AM »
Mine can be a git when cold. Found this works for me: fuel on,ignition on kill switch in off position, hold throttle wide open, two/three kicks, kill switch to run, one kick and she lives.
11
CB500/550 / Re: Idle issues« on: May 16, 2017, 08:13:32 AM »
Honestly can't remember if it's third or fourth down. Think I'm third down but did drop to fourth at one point.
12
CB500/550 / Re: Idle issues« on: May 15, 2017, 10:52:30 PM »
Thats stock jetting I'm running 40 pilot and 110 main 1 1/2 out on the a/f screw. That's with 069a carbs, unipods and 4 into 1 header with a short reverse megaphone.
13
CB500/550 / Re: Cb 550 motogadget m unit« on: February 07, 2017, 12:43:45 PM »
M-unit uses ground signal to switch so what would be a 12v feed to the switches is grounded instead.
14
CB500/550 / Re: Cb 550 motogadget m unit« on: February 07, 2017, 10:37:39 AM »
From the manual you can set what controls you have on the bars.
7.7 Handle Bar Controls Three different types of handle bar controls are compatible with m-Unit. The particular type which will be used with m-unit must set in the setup menu. Configuration A) – 5-push button controls - turn lights left - push button - turn lights right - push button - low beam / high beam - push button - start - push button - horn - push button Configuration B) – Harley Davidson and BMW controls - turn lights left - push button - turn light right - push button - low beam / high beam - switch - start - push button - horn - push button Configuration C) – most Japanese and European motorcycles - turn lights left / right - 3 way switch - low beam / high beam - switch - start - push button - horn - push button configuration D) – new Ducati models - turn lights left / right - 3 way switch - low beam / high beam - push button - start - push button - horn - push button configuration E) – 4-push-button controls - turn lights left - push button - turn lights right - push button - low beam / high beam - push button - horn - push button - start = left turn + light simultaneously - kill switch = right turn + light simultaneously In case of using the OEM handle bar controls together with m-Unit; head light flashing push button is not applicable. There is also no possibility to switch the parking light by the m-Unit. Additional safety switches like side stand switch have to be connected as shown in chapter 7.9. 15
CB500/550 / Re: Cb 550 motogadget m unit« on: February 06, 2017, 02:13:00 PM »
You can use stock switches but have to select that setting in the m-unit menu. Also you have to wire them to switch ground not 12v.
Pages: [1] 2
|