Recent Posts

Pages: [1] 2 3 ... 10

Project Board / Re: Teds new project a CB500 K1 mostly version 0.5 circa 1972.

« Last post by Laverdaroo on Today at 11:10:43 PM »

That’s looking good Ted, shiney shiney

Loving the rims!

Sent from my iPhone using Tapatalk

Project Board / Re: Teds new project a CB500 K1 mostly version 0.5 circa 1972.

« Last post by Laverda Dave on Today at 11:07:55 PM »

Looking very good Ted, you've been busy👍

CB350/400 / Re: Anyone recognise this bit?

« Last post by Laverdaroo on Today at 11:03:01 PM »

Well if it is, it left no mark Ted

Sent from my iPhone using Tapatalk

CB350/400 / Re: Anyone recognise this bit?

« Last post by McCabe-Thiele (Ted) on Today at 10:52:01 PM »

Might not be a 0.22 how about a 0.177.🤔🤔🤔

CB500/550 / Re: Rear wheel rotation stiffens up when tightening axle problem.

« Last post by McCabe-Thiele (Ted) on Today at 10:46:36 PM »

I had no issues Mike when I did my 400 rear wheel so I was well miffed when the 500 did not work out first fit.

After chatting to Ken on reflection I obviously did not fit the right side bearing fully home. The 500 has that short extra spacer that fits into the left bearing as well as the long center spacer. Make sure you fit the short spacer fully home into the fixed left side bearing before you fit it.

CB350/400 / Re: Anyone recognise this bit?

« Last post by Laverdaroo on Today at 10:00:20 PM »

I’m not sure but that’s not even a 22’

Got me flummoxed that, no bloody idea and gonna drive me nuts now! Grrrrr!

Cheers chaps,

Sent from my iPhone using Tapatalk

CB350/400 / Re: Anyone recognise this bit?

« Last post by Johnny4428 on Today at 09:58:28 PM »

Any snipers around there Roo? 😂😂

CB350/400 / Re: Anyone recognise this bit?

« Last post by Laverda Dave on Today at 09:58:22 PM »

I've had a good few 400/4 carbs apart and I've never seen anything like that before! Maybe the PO had the tank off at some time to do something else and dropped that part down there and you know the agro of dropping something down there and a) seeing where it actually went and b) trying to fish it out! BUT....the shape of the indent at one end does look like the lifter but if it is someone has cut the end off and why?