Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hairygit

Pages: 1 2 [3] 4 5 ... 172
31
CB500/550 / Re: Smoking coil - help!
« on: June 09, 2021, 04:20:37 PM »
Welcome to motorcycling Stone Age style! If you rotate the engine on the kickstart, the other set of points should open about half an engine rotations time. Yes, the points when they are closed are energising the coil they are connected to, when they open, the coil produces the spark. As regards whether you have damaged the coil, the only was to know is try it! Smoke, to replace that which was escaping from the coil used to be available at Lucas and some auto electrical specialists, but is as rare as camera film these days

Sent from my POT-LX1 using Tapatalk


32
CB500/550 / Re: headlight adjustment (cb550f2 us import)
« on: June 09, 2021, 01:00:28 PM »
That only applies to household bulbs Steve, to reduce power consumption in the home (leaving more available for people to charge their electric cars?) As motor vehicles produce their own electricity halogen bulbs will continue to be available. Funny enough, it's 10 years since standard bulbs for household use were banned from manufacture (EU meddling again!) and I'm glad I bought a load for my photographic enlarger as one blew last night!

Sent from my POT-LX1 using Tapatalk


33
CB500/550 / Re: headlight adjustment (cb550f2 us import)
« on: June 09, 2021, 10:08:40 AM »
U. S. Ahead lights are made to dip to the right (straight into oncoming traffic here in UK) Usually it is the fluting (ridges) in the lens that are set to direct low beam, so no, replacement is the only real option. The good news is, they are a standard 7 inch headlight as used by millions of cars until very recently, so there are many pattern ones out there (think Landrover defender, original mini, Morris Minor etc) also DSS does a single one for less than £30.

Sent from my JNY-LX1 using Tapatalk


34
CB350/400 / Re: CB400f exhaust gasket size
« on: June 08, 2021, 11:10:41 PM »
How are the downpipes held to the collector, 2 welded, 2 clamped or all 4 clamped?

Sent from my JNY-LX1 using Tapatalk


35
Project Board / Re: 75 CB400 "Dad's old bike" project
« on: May 31, 2021, 08:54:01 PM »
So sorry to hear of your loss, I was wondering the other day what had happened to you and your Wotsits munching helper (Jess?) Stay safe, give our regards to your daughter, hopefully she has the bug now and will want a bike of her own when she is old enough, so don't lose touch with us on here!

Sent from my POT-LX1 using Tapatalk


36
New Member Introductions / Re: Newbie
« on: May 27, 2021, 03:11:43 PM »
Hi and welcome, nice looking bike (except that hideous yank seat!) and great to see stock pipes on one, VERY scarce nowadays.

Sent from my JNY-LX1 using Tapatalk


37
CB750 / Re: F1 rear wheel alignment
« on: May 24, 2021, 12:10:46 AM »
The bearing behind the locking ring will almost certainly be the culprit. Remove the locking ring and tap the bearing home (ONLY on the outside race!) and you will notice a change in the sound when you hit it and it's fully home. And Do Not machine anything of the spacer, it will not solve the issue!

Sent from my JNY-LX1 using Tapatalk

38
Humour / News Headlines
« on: May 17, 2021, 05:27:14 PM »
Today's Top stories

Sent from my JNY-LX1 using Tapatalk


39
So removed coils and  rechecked ohms , (which were from DS  but not standard ones - 'cos half the price! )  Ohms for primary coil 3ohms and secondary coil 11k ohms.
removed coils from 400/4 runner and checked them which gave 5 ohms and 15k ohms respectively, fitted to rebuild and although not running as yet, still need to fine tune timing but sounded much more powerful on attempting to start. Unfortunately I bought the coils form DS over 3 years ago so doubt if I can return them  :(.
So beware the perils of pattern parts!
The ghost of Bitsa will be pissing himself laughing at the last line of that post!

Sent from my JNY-LX1 using Tapatalk


40
Misc / Open / Re: Any appetite for fighting the DVLA?
« on: May 01, 2021, 04:53:15 PM »
My objection to VED on fuel is we would lose out as most of our real bikes are currently exempt, so putting it on fuel would be detrimental to most of us on here!

Sent from my JNY-LX1 using Tapatalk


41
CB750 / Re: Spoke advices please.
« on: April 30, 2021, 12:32:54 PM »
Well, 40 bits of metal not much thicker than piano wire, all under equal tension is all that stops the wheel collapsing under a quarter of a ton of bike, that's without the weight of rider and passenger, the shocks from bumps in the road, and the forces of inertia when cornering/acceleration or braking. Those little bits of metal have incredible forces going through them, enough that Honda fitted 40 of them, and the 36 on 400/4 and below would never support the stresses of a 750.

Sent from my JNY-LX1 using Tapatalk


42
Misc / Open / Re: Any appetite for fighting the DVLA?
« on: April 30, 2021, 12:25:31 PM »
Problem is bikes make up less than 1% of road traffic in the UK, (but account for 30% of road fatalities according to insurers) so we are the minority on the roads. Which is why successive governments have got away with screwing us over. Road tax used to be about how much damage vehicles did to the roads, which is why HGVs get stung for thousands each year, but bikes do not damage the roads, so really they should all be tax exempt. Truth is we Are a minority, governments know that, so we will always get stung because the votes they risk losing are negligible, but they make 3 times what some cars pay for road tax from us, and we can shout and stamp our feet, but won't be heard.

Sent from my JNY-LX1 using Tapatalk


43
CB500/550 / Re: What's it worth
« on: April 30, 2021, 11:31:19 AM »
Where are you seeing a vin plate odd-job, I can't see one looking on my phone? My 750F1 is a UK bike and had a vin plate on the right hand front downtube, registered Dec 75, so it could be a UK bike.

Sent from my POT-LX1 using Tapatalk


44
CB750 / Re: Spoke advices please.
« on: April 30, 2021, 11:00:24 AM »
Answer to Q1. do NOT use it on a public road now you have mentioned it on here. Anyone can read that statement without being a member, so IF you were involved in any kind of incident, your insurers would just laugh at you, as you have used it KNOWING thee is a potentially dangerous fault in it. Insurers and other agencies have software which can scour the net for that kind of thing, and they do use any means to escape liability.
On to Q4, treat it as meths, don't drink it, avoid prolonged skin contact. Great for cleaning, degreasing, burning in spirit lamps/camping stoves etc

Sent from my POT-LX1 using Tapatalk


45
Out & About / Re: Anyone know the girl?
« on: April 27, 2021, 08:20:14 PM »
She didn't ride the bikes,

All the riding was done by Bill Ivy.

Which explains why a Harley went so quickly.

The film is regularly on channel 81 Talking pictures.

Sent from my SM-A750FN using Tapatalk
John, had you been drinking watching that? Fast and harley are not words that belong in the same sentence!

Sent from my JNY-LX1 using Tapatalk


Pages: 1 2 [3] 4 5 ... 172
SimplePortal 2.3.5 © 2008-2012, SimplePortal