106
CB350/400 / Camshaft spacer
« on: April 13, 2016, 07:29:36 AM »
Good morning all.
Following a pleasant evening in the garage flitting my pistons (is there a special 'knack' or tool to refit the piston circlips, long nose pliers and swearing don't appear to work.....) I have a camshaft question that more knowledgeable folk than I could answer......
When I bought the 'project' in its various boxes the camshaft had a large washer attached to it. The camshaft lobes resembled a threepenny bit and I bought a good s/h from the US of A. Question.......should I refit the large washer, my old 400/4 didn't have this fitted, was it for an early camshaft? If I do have to refit it where should it go, camshaft flange side or the other side of the sprocket? How do I tell an 'early' camshaft that may need the large washer from a 'late' camshaft that doesn't need it? I cannot find any reference to the large washer in the Honda parts book or the Haynes manual. I have checked on the forum as well. Maybe the 'large washer' was lying around on the guy's floor and he thought it was a bit of the 400/4 jigsaw?
Hope one of the forum guru's can help .
One last thing, I ordered a couple of new 'knock' bolts as they are referred to in the Honda parts book to fix the cam sprocket onto the cam, the part number has been superseded and the bolts I was supplied with by my Honda dealer are flange type, is this correct?
Dave
Following a pleasant evening in the garage flitting my pistons (is there a special 'knack' or tool to refit the piston circlips, long nose pliers and swearing don't appear to work.....) I have a camshaft question that more knowledgeable folk than I could answer......
When I bought the 'project' in its various boxes the camshaft had a large washer attached to it. The camshaft lobes resembled a threepenny bit and I bought a good s/h from the US of A. Question.......should I refit the large washer, my old 400/4 didn't have this fitted, was it for an early camshaft? If I do have to refit it where should it go, camshaft flange side or the other side of the sprocket? How do I tell an 'early' camshaft that may need the large washer from a 'late' camshaft that doesn't need it? I cannot find any reference to the large washer in the Honda parts book or the Haynes manual. I have checked on the forum as well. Maybe the 'large washer' was lying around on the guy's floor and he thought it was a bit of the 400/4 jigsaw?
Hope one of the forum guru's can help .
One last thing, I ordered a couple of new 'knock' bolts as they are referred to in the Honda parts book to fix the cam sprocket onto the cam, the part number has been superseded and the bolts I was supplied with by my Honda dealer are flange type, is this correct?
Dave