This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Lynx
Pages: 1 2 [3] 4 5 ... 27
31
« on: March 14, 2020, 06:44:44 PM »
That's what I thought too until u saw the diagram   . Sent from my HTC Desire 530 using Tapatalk
32
« on: March 14, 2020, 06:06:55 PM »
Has anyone any idea what this is? Someone in my village bought it at an autojumble but we don't know what it's off .    Sent from my HTC Desire 530 using Tapatalk
33
« on: September 09, 2017, 08:13:03 AM »
I know the ones. They have nuts in the inside. I used some stainless steel ones from Screwfix but make sure they are not too long or they will damage your crankcase.
Sent from my HTC Desire 530 using Tapatalk
34
« on: September 04, 2017, 04:49:32 PM »
I put the down pipes into the collector with copper grease, so I can get them out again.
Sent from my HTC Desire 530 using Tapatalk
35
« on: September 03, 2017, 06:37:04 PM »
Hey Ian. Make sure you haven't lost a brass blanking ball as I did. Thread on here somewhere.
Sent from my HTC Desire 530 using Tapatalk
36
« on: August 01, 2017, 04:41:38 PM »
Hi Paul. I did resolve the problem in the end by replacing the whole of the lifting mechanism with good secondhand stuff from Germany via eBay. Thanks.
Sent from my HTC Desire 530 using Tapatalk
37
« on: May 10, 2017, 05:04:25 PM »
If it's just rich at idle all you have to do is open the idle air screws 1/4 turn.
38
« on: January 25, 2017, 03:51:52 PM »
I had this problem with my 400 when first rebuilt. I had to replace the whole lifting mechanism to sort it.
39
« on: October 01, 2016, 02:35:13 PM »
Strange design 🤔
Sent from my HTC Desire 530 using Tapatalk
40
« on: October 01, 2016, 11:24:21 AM »
They'll be held in with an o ring.
Sent from my HTC Desire 530 using Tapatalk
41
« on: September 30, 2016, 09:49:57 AM »
Have you used compressed air on them? I managed to blow out a small brass blanking ball once without realising. I had the carbs off 3 times before I found the problem.
Sent from my HTC Desire 530 using Tapatalk
42
« on: September 28, 2016, 10:30:09 PM »
Well done 😊.
Sent from my HTC Desire 530 using Tapatalk
44
« on: September 28, 2016, 10:13:18 PM »
Aaron,
Have you tried sucking the fluid through from the bleed nipple with a vacuum?
45
« on: April 22, 2016, 03:07:05 PM »
15wt Fork oil worked well in mine.
Pages: 1 2 [3] 4 5 ... 27
|
Show Posts