This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bryanj
1
« on: Today at 03:29:17 AM »
That looks suitably loud
2
« on: May 26, 2024, 11:20:04 PM »
Which O ring? Cover or pump to crankcase?
3
« on: May 26, 2024, 11:18:47 PM »
If its enough to spill out of the trough its enough, dont forget the starter is not spinning the engine at running speed and the faster the engine turns the more the pump works
4
« on: May 26, 2024, 08:26:27 PM »
That collar and bearing usually need a hydraulic press to remove and from memory there is a small cross section O ring between collar and bearing but its not shown in any books. Honda use to recommend changing shaft with bearing and the cost extra used to be negligable
5
« on: May 26, 2024, 08:22:59 PM »
Back in 76 as a young(er) rider i fitted a h4 unit and with lights on stayed 1 gear lower than in daylight, not forgetting in UK we can switch lights off
6
« on: May 26, 2024, 07:49:40 PM »
Pic of original
7
« on: May 26, 2024, 07:45:36 PM »
Are these the bulbs, pic of halogen
8
« on: May 26, 2024, 07:39:40 PM »
Great innit, but they failed40 yr ago as well
9
« on: May 26, 2024, 07:38:34 PM »
That is a standard car bulb and there is an H4 equvalent, i will see if i can find a number for you cos im bored
10
« on: May 26, 2024, 12:36:57 PM »
550 are the same, they are a swine to remove and i do have one of those in bits, i will try and get some out next weekend
11
« on: May 26, 2024, 12:34:53 PM »
That was my thought
12
« on: May 26, 2024, 12:33:39 PM »
In that cas the fuse box itself is suspect as the clips get warm, loose tension on the fuse end, get warmer still, melt the plastic and even the solder connections.
Also ignition switches have been known to give intermittent contact
13
« on: May 26, 2024, 08:42:54 AM »
What exact model is it as 500 and 550 differ a lot
14
« on: May 25, 2024, 09:04:51 PM »
It shouldnt, the only connection is through the small red wire from terminal with battery cable to fuse
15
« on: May 24, 2024, 05:10:42 PM »
In theory, with main jet removed it should push down from the top but i havent gone that far with pd carbs, i usually point blank refuse ro work on them.
|
Show Posts