This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - rosco
91
« on: July 09, 2019, 01:22:32 PM »
Hi Julie Hope this has cured Grahams problem on the 750 brat
92
« on: June 20, 2019, 10:58:15 AM »
Thanks Phil Very useful Ross
93
« on: June 19, 2019, 09:27:53 PM »
Did you have to send in photos of the complete bike and frame,engine numbers or just the form Only ask as very close to registering mine a CA77 1966
94
« on: June 19, 2019, 09:21:32 PM »
Your Just rubbing it in Your bikes work???
95
« on: June 10, 2019, 08:47:04 PM »
Hi Sorry but no chain case Ross
96
« on: June 05, 2019, 08:44:13 PM »
Just been out and tried the oil filter bolt, and it will not fit, as it is 20mm. Rotor thread 18mm x 1.5
97
« on: May 29, 2019, 09:35:52 PM »
Again personal preference But i think it gives a visual balance Looks like a baby 750 Nice Agree with Julie If it keeps the bikes on the road then its ok
98
« on: May 27, 2019, 11:55:28 AM »
But why is it always me  ?
99
« on: May 26, 2019, 09:19:35 PM »
Sorry, just spotted spares section, DOH !! so re-listed in that section, before i get angry replies for posting on here Can you tell I'm a newbie?? Ross
100
« on: May 26, 2019, 08:38:42 PM »
Hi Guys and Gals Don't want to turn this into a shop But having a clear out and have loads of parts for Honda 305cc C77/CA77/CB77 and wanted to give peeps on the forum a chance before they go on fleabay. Frame, Turtle fuel tank,Engine parts etc etc Please contact through messages Cheers Ross
101
« on: May 24, 2019, 12:14:10 PM »
Update on correct colour Following advice from Deano I contacted Honda uk Today, i received a reply to say my colour code is R6CS Candy Antares Red. Thanks for all your replies. Shows the power of the forum to get things done Keep it up Ross
102
« on: May 21, 2019, 09:53:12 AM »
Just checked my heads and both, on the inlet side the guide tops are parallel with a provision to take a seal. Whereas the exhaust guides have a conical top with no provision for a seal. I may be unlucky and both heads may be from an early model Yet looking at parts catalogue it only shows seals on inlet side. Confused??
103
« on: May 20, 2019, 08:51:07 PM »
Just to throw this one in Just stripped my 1978 400/4 head for cleaning It only has seals on the inlet. Has someone else been in there before me and left them off? ?
104
« on: May 20, 2019, 08:36:30 PM »
Don't forget when rebuilding the gearbox back into the crankcase ensure its put together while in neutral the pip on the selector barrel visible through the switch hole The outer selector forks have the flat sides facing the centre the centre one will be self explanatory
105
« on: May 20, 2019, 08:19:54 PM »
I have a motad Sounds nice [ when running stripped now for rebuild ] looks neat
|
Show Posts