This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - boilermaker1
61
« on: October 23, 2014, 10:43:55 AM »
Thanks Trig
62
« on: October 22, 2014, 10:54:56 AM »
Hi
does anyone have the torque specs for a 400f head? and what order
are they tightened in?
Thanks
63
« on: September 02, 2014, 02:33:03 PM »
Hi. My old fuel pipe and overflow pipes are hard and brittle
Anyone know of suitable pipe to replace them with?
Thanks
64
« on: August 10, 2014, 09:55:35 AM »
This is great, Thanks guys
65
« on: August 08, 2014, 09:42:47 PM »
Hi. Finally time to start putting my 1975 400 f back together,
Hoping someone has a diagram of the proper way the wiring loom
fits on the frame. any help would be great
Thanks
66
« on: December 03, 2013, 05:56:11 PM »
Thanks for replying and posting photo's, Looks great
67
« on: December 01, 2013, 07:51:54 PM »
Hi, I am restoring /tidying up my old 400 Four.
Bike is low mileage and engine runs very well.
I want to paint engine but do want to strip it down,
Engine is out of frame and sealed so was thinking
of either getting it soda blasted or vapour blasted.
Has any one painted their engine with out taking it apart
and got good results. View comments greatly appreciated.
68
« on: March 18, 2013, 10:23:17 PM »
Again thanks for advise and photo's..
I may now have cases polished, what brand or type of lacquer should I use?
69
« on: February 19, 2013, 07:07:18 PM »
Thanks that very helpful, What about preparation. Did the engine need to be acid etched?
70
« on: February 18, 2013, 01:26:04 PM »
Hi, I am currently restoring my 1975 CB400 F. I want to paint the engine but have no
experience with painting.. I need to know what paint gives a good finish, What prep work needs to be done etc, Any help would be great
|
Show Posts