Recent Posts

Pages: [1] 2 3 ... 10

SOHC Singles & Twins / Re: CB360 Wiring question

« Last post by Craizeehair on Today at 11:29:02 AM »

Thanks all, I will have to give it a good looking at over the weekend, along with a good dose of head scratching. I was hoping someone would say that they are surplus to requirement, not needed, unused and ignore them

SOHC Singles & Twins / Re: CB360 Wiring question

« Last post by McCabe-Thiele (Ted) on Today at 10:59:00 AM »

Brake pressure switch?

Desperately Seeking!! / Re: CB400 Rear Brake Rod 43451-377-000

« Last post by Deano400 on Today at 10:58:41 AM »

Thanks Dave, will take a look.

SOHC Singles & Twins / Re: CB360 Wiring question

« Last post by AndyD on Today at 09:44:42 AM »

I think that light green / red is used for neutral switch / light on the CJ models so maybe that somehow?
I also seem to remember that there were one or two unused wires somewhere on the CJ loom but can't recall where.

Cheers,
Andy

CB350/400 / Re: Anyone recognise this bit?

« Last post by Laverdaroo on Today at 01:10:24 AM »

You legend, cheers for that. I actually thought they were fixed in the cap or part of it. Never knew they came out at all. Brill, that’s a great result

Sent from my iPhone using Tapatalk

CB500/550 / Re: Rear wheel rotation stiffens up when tightening axle problem.

« Last post by McCabe-Thiele (Ted) on Today at 01:00:47 AM »

It's probably between my ears rather than reality - when I did my rectification fit of the right bearing instead of using my lump hammer as previously to get it fully home - I used my Orange Plastic shot filled hammer for the final strike - thinking it might stop a rebound.

CB350/400 / Re: Anyone recognise this bit?

« Last post by McCabe-Thiele (Ted) on Today at 12:33:03 AM »

Well spotted Ozzybud I did not realise they come out!

Knowing your luck Roo it will be the last one you check that's missing!

Project Board / Re: Teds new project a CB500 K1 mostly version 0.5 circa 1972.

« Last post by McCabe-Thiele (Ted) on Today at 12:24:20 AM »

Yes they are already painted in gloss Black in safe storage - done by the bloke in Ilkeston who was recommended to me by a sohc member (Seaman Phil?).

No petrol tap or filler cap fitted as yet - I have a tap kit & new filler cap to fit.
All the big ticket items purchased just some minor oddments for the final fettle.