Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Johnny4428

Pages: 1 ... 134 135 [136] 137 138 139
2026
Misc / Open / Re: 1977 550 K3 Tale of woe.
« on: July 05, 2020, 10:09:28 AM »
That’s a shit situation to end up in, but glad you are getting sorted now. Lie and deny. A terrible trait.
Is incompetence curable.😡

2027
CB500/550 / Re: Cb550k3 Rectifier
« on: July 05, 2020, 07:47:55 AM »
Good fix Mike! Was that a similar type rectifier? Wasn’t sure of the durability of these cheapo components. The temptation to spend £4 compared to £60 was overwhelming.😂

2028
CB500/550 / Re: Cb550k3 Rectifier
« on: July 04, 2020, 09:21:35 PM »
Thought I did well finding bits and pieces of correct colour wire, unfortunately no green heat shrink. Added to shopping list  along with black cable ties!!

2029
CB500/550 / Re: Cb550k3 Rectifier
« on: July 04, 2020, 07:30:38 PM »
Your absolutely right just doesn’t look right! Quick get the side cover on before anybody else notices.😂😂

2030
CB500/550 / Re: Cb550k3 Rectifier
« on: July 04, 2020, 04:09:37 PM »
Fitted today, all seems fine, too wet for road test but passed garage run testing.
[ Guests cannot view attachments ]

2031
CB500/550 / Re: Silvers electronic ignition
« on: July 03, 2020, 09:19:48 PM »
That method worked for me. I just got confused by the instructions, (I quite often do mind)😂😂

2032
CB500/550 / Re: Silvers electronic ignition
« on: July 03, 2020, 07:16:44 PM »
I didn’t have any success setting by instructions either, I just kept rotating crank and resetting plate until it was set.
It is the same as mine. The light comes on with supply interruption, ie spark time.

2033
CB500/550 / Re: Silvers electronic ignition
« on: July 03, 2020, 06:38:05 PM »
Hi, I fitted one short ago after about half turn of crank to activate the light comes on then goes out and the next time the light comes on continuing the clockwise rotation the 1,4 should line up if correctly adjusted. That’s probably as clear as mud, but mine seems to be running fine. Good luck! Johnny.

2034
CB500/550 / Re: Cb550k3 Rectifier
« on: June 28, 2020, 07:33:08 PM »
Thanks very much guys, that rectifier looks very interesting, anybody else tried one? I think at that sort of money you can’t go wrong. Seen a couple on dk spares but everything advertised 39.99 postage and they don’t use Royal Mail which is cheapest for sending to Orkney, especially something that can be slipped into a small Jiffy bag.

2035
CB500/550 / Cb550k3 Rectifier
« on: June 28, 2020, 05:57:45 PM »
Hi everybody, anybody cruising today? Went for a run just about 18miles switched to reserve fuel on my return to town so filled up, pushed starter button wouldn’t even turn over, thank god there’s a kick start lever. I came home checked voltage on battery 11.3 volts! Not good. No power whatsoever getting from alternator to battery. I have a suspect rectifier with a slightly fried red/white wire. Question is replace with just rectifier or replace with regulator rectifier. About the same cost wise from what I’ve seen so far.

2036
CB750 / Re: Fancy a project?
« on: June 26, 2020, 01:37:29 PM »
That reminds me of a C90 someone delivered to me some time ago, put some petrol in and hooked up a battery and started and ran sweetly. The PO assured me that it hadn’t run for 30 years, took the engine out and dumped the rest. Ironically delivered to the recycling centre, can they recycle rust?

2037
CB750 / Re: RPM hang at idle throttle.
« on: June 22, 2020, 07:03:43 PM »
Hi for what it’s worth I thought that characteristic was something that I was just going to have to live with on my K3. Until I removed carbs for the third time and pulled pilot jets cleaned system thoroughly. It now idles as it should runs smoothly and no longer hangs on to revs. The reason I pulled the carbs was because of the poor starting and rough idle.

2038
CB750 / CB750K3 replacement Seat
« on: June 20, 2020, 08:55:30 AM »
Hi all, Any recommendations for the replacement seats from P&K Classics. I had my 550k3 seat refurbished by them and I was very happy. Just wasn’t sure about the reproduction base etc. Looking for 750K3 seat.

2039
CB500/550 / Re: PD46A setting
« on: June 09, 2020, 10:07:16 AM »
Cheers Bryan, yes I remember these when I stripped the carbs. They were all replaced, the bike is running well but not starting well when cold. I do have resistor plugs fitted at the moment but have another set of non resistor plugs to fit. Also dropping back to correct pilot screw setting might help. Thanks for your help!

2040
CB500/550 / Re: PD46A setting
« on: June 09, 2020, 07:48:13 AM »
Thanks very much! found in Alladins Cave, just as I thought 1 1/2 turns. Yes they don’t make it easy I was beginning to think I had a set of 500 carbs, which I probably do but common to 550 also.

Pages: 1 ... 134 135 [136] 137 138 139
SimplePortal 2.3.5 © 2008-2012, SimplePortal