Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Bryanj

Pages: 1 ... 661 662 [663] 664 665 ... 674
9931
Misc / Open / Re: Got any Snow yet???
« on: February 05, 2009, 01:42:16 PM »
At least youre not talking to me instead of getting the coffee!!

9932
CB750 / Re: 750 K2 Rebuild
« on: February 04, 2009, 03:08:10 PM »
If you look arround the thread edge of the screwed in retainer you will see 4 points where it looks like somebody used a centre punch. you need to dill down with a 1/8 drill (ish) till you have removed the deformed metal to allow the retainer to unscrew.

Now i seem to remember that one of them is a L/H thread and i think its the rear---but dont take that as gospel as its been a LONG time.

Dont think much of your chromer if he has done a hub complete with bearing and grease in it!!

9933
CB500/550 / Re: petrol tank paint designs
« on: February 04, 2009, 03:03:23 PM »
If its 550 should fit all 500/550 BUT you may need the same year seat as tank as the lenths varied

9934
Misc / Open / Re: Got any Snow yet???
« on: February 03, 2009, 01:36:09 PM »
OK I'm peed off!

It is NOT the worst snow in 20 years-----its just the worst in LONDON for 20 years!!!!!



9935
CB750 / Re: 750 K2 Rebuild
« on: February 03, 2009, 06:52:14 AM »
Do you mean you have chromed the hubs? in which case getting the retainers out will wreck the chrome.

have you drilled out the "stakings?"

Rust at the top of the legs dont show as its under the headlamp brackets

9936
Misc / Open / Re: Got any Snow yet???
« on: February 02, 2009, 12:09:38 PM »
Chipping Norton at 3am was every so pretty --NOT--- with a 53 ft artic

Got some in Glos but goes from 1/2 inch to nowt regularly. Then again just started snowing again.

Off back to bed now F'in postie!!!

9937
CB650 / Re: carbs again!
« on: January 31, 2009, 04:14:04 PM »
try a new plug and carb balance---running with the bad pilot may have wrecked the plug

9938
CB750 / Re: Smokey 750
« on: January 31, 2009, 04:12:46 PM »
Tell you what, if the bores were worn and oval that motor has been abused and run with no aircleaner, I can remember a 120,000 miler where even the ring gaps were still in tolerance!!!

9939
Misc / Open / Re: Helicoil Kits
« on: January 30, 2009, 05:46:24 PM »
G5 has 'lecy start CJ is kick only, apart from that mostly same.
BEFORE you lay out on an exhaust remove the top cover and check operation of cam chain tensioner and state of camchain plus cam bearings all it will cost is time + gasket goo. Clean out centrifugal oil filter on end of crank. At one time you could get pattern silencers to fit original front pipes. Mostly same as CB360 (more common in US) and i think Dave Silver has many parts.

650 plug give me a call sometime and i will talk you through it as best i can.

Any other help ask and i will try

Regards Bryan

9940
Misc / Open / Re: Helicoil Kits
« on: January 30, 2009, 12:45:49 PM »
Now if this is a 750 and you have the head off those 6mm threaded studs/bolts holding the cam towers strip out regularly and better than helicoil is "keensert" which you can find at:-

http://www.specialty-fasteners.co.uk/category_sublist.php?catid=143&colorid=2&procatid=144&gclid=CJbwg_OntpgCFZiT3wodAXcFZg

and look at the catalogue. They do do the spark plug one but you have to tap out to M16 and i dont know if the head has enough meat for that!!

9941
Misc / Open / Re: Helicoil Kits
« on: January 30, 2009, 12:28:58 PM »
to give you some idea of prices look at:-

http://www.ar-sheldon.com/acatalog/Helicoil_Metric_thread_repairkits_Kits.html#a5403_2d8

and

http://www.engineering-supplies.com/show.asp?id=5382.

Dont forget that will only do the M12x1.25 (NGK "D") sparkplugs

9942
CB750 / Re: Looking for a connector block
« on: January 30, 2009, 12:00:01 PM »
They are a fractionaly different size, I think the bullets are slightl bigger from memory which makes a good fit into the Honda loom connectors just crimp up the females a bit to make the original bullets fit tight----sounds a bit perverted when i re read that!

Dont forget the 2 and 3/4 way females with shrouds when you order

9943
CB750 / Re: Looking for a connector block
« on: January 30, 2009, 04:06:00 AM »
K1 only had single fuse not fuse box

9944
CB750 / Re: Smokey 750
« on: January 30, 2009, 04:05:06 AM »
valve stem seals

9945
Misc / Open / Re: Helicoil Kits
« on: January 29, 2009, 06:13:06 PM »
Get Suzuki bits from www.cmsnl.com and look up the 500 of the right year, all the same except bores.

Suzuki:-Watch for siezed brakes and swing arm bushes/brearings (no greasers and kin expensive!!).

Honda:-If its pre dream it has to be G5---Disc brake, strip engine in frame but problematic camchain tensioner OR K4--drum brake, engine out to do anything.

I have some books for the G5 somewhere but no promises

Pages: 1 ... 661 662 [663] 664 665 ... 674
SimplePortal 2.3.5 © 2008-2012, SimplePortal