This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - oldtuggie
1
« on: January 19, 2024, 11:31:12 AM »
1976 550 four supersport, any tyre recommendations would be gratefully received
2
« on: May 07, 2023, 09:33:21 AM »
Hi all
Need new tyres and any recommendations would be gratefully received.
3
« on: April 02, 2022, 01:13:24 PM »
Thanks for the replies guys, brilliant advice.
2&3 cylinders had stopped firing swapped condensers but it made no difference swapped leads on coils and plugs an 2&3 fired immediately, I assumed it was the coil never thought of the lead or cap.
4
« on: April 02, 2022, 02:40:29 AM »
1976 550 four f1 supersport
Hi can anyone advise me how to use a multimeter to test a suspected faulty ignition coils
5
« on: July 24, 2021, 09:25:10 PM »
Ok thanks
6
« on: July 24, 2021, 08:43:56 PM »
Ok thanks I wasn't sure if I should do it sooner after a rebuild
7
« on: July 24, 2021, 08:33:04 PM »
Hi
Can anyone advise me at what mileage I should change the oil and filter when running in a fully rebuilt engine.
Thanks in advance
8
« on: July 22, 2021, 08:14:25 PM »
Kitty is a very lovely lady!
9
« on: July 19, 2021, 09:26:49 PM »
Thanks for the replies, just insured the bike so I think Autoaid sounds like the one for me
10
« on: July 18, 2021, 11:09:14 PM »
Hi
Has anybody got Classic bike breakdown cover and if so which company do you use.
I want it for my 76 550 f1 supersport but can't get any cover off the big companies because of the age of the bike.
11
« on: June 02, 2021, 02:31:37 PM »
Ok cheers
12
« on: June 02, 2021, 08:28:20 AM »
Hi
Thanks for the suggestion, I have found a set of videos on YouTube from a guy in Texas.
He works with these old Hondas and the business name is Classic Octane.
He has a full strip and rebuild film and a balancing film, can't recommend these enough for anyone starting out working on these bikes
13
« on: June 02, 2021, 12:20:31 AM »
Hi
Thanks for the replies, I have sourced the part needed from a guy locally but thanks for the offer Brianj
14
« on: June 01, 2021, 05:36:37 PM »
1976 550 f1 supersport
Hi I've been having problems with a sticking slide so I am rebuilding the carbs and when I have removed the linkages one of the little trumpets that sit inside the spring and drops into the connecting arm is missing , it's above the spring in the picture.
Please can anyone tell me where I can source this part or has anyone got one that I can buy.
The rebuild kit mixture screw is different to the original as it has a solid shaft,whereas the original is drilled up the center and has a hole in the shift, should I refit the original.?
15
« on: August 04, 2020, 12:04:33 PM »
Thanks
It is leaking from behind the adjuster nut I have fitted the wrong seal I will replace it with an o ring
|
Show Posts