This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - 4wDaz
91
« on: May 26, 2020, 08:54:26 AM »
I got the same answer when i bought 4 float needles for a CBX 550
Do you still have the cbx ? I also own one, currently on sorn to make room for a modern Kawaski 750 but its a cracking little bike 
92
« on: May 25, 2020, 04:41:18 PM »
Interesteing to see what DSS says
The PCRK CB400F carburettor kits are an aftermarket kit so this may explain the difference in engraving. We are not aware of an issue with the kits and have been supplying the same kits for many years.
93
« on: May 23, 2020, 05:24:46 PM »
Appreciate that but I’ve got 4, that’s if there all the same when I clean them. Thanks
94
« on: May 23, 2020, 02:04:14 PM »
I think i may have to invest in a set
95
« on: May 23, 2020, 02:02:45 PM »
Thanks, by Just looking you can see the taper is different, there is no needle tube in the kit either, I will have to get In touch with silvers see what they say 
96
« on: May 23, 2020, 01:16:36 PM »
Hi all, got a keyster carb rebuild kit from silvers, needle is a D22 but the one in the carb is a 18234, any ideas if the d22 will be ok ? Thanks
97
« on: May 23, 2020, 09:49:56 AM »
Anyone used the Morgan Carbtune ?
98
« on: May 18, 2020, 09:25:39 AM »
Thanks for the replies, i found some orings which came with the bike which are 1.9mm x 5.8mm in a honda bag which i thought could have been what i needed
99
« on: May 17, 2020, 08:12:24 PM »
Hi, Just about to start rebuilding the carbs, does anybody know what size the o rings are for the Tee where the fuel pipe goes on ? Thanks
100
« on: May 15, 2020, 12:54:39 PM »
Its done with a knurling tool, have a look on Youtube for knurling on lathe, its dead easy to do
101
« on: May 14, 2020, 08:14:09 PM »
I feel a production run coming …
Sent from my iPhone using Tapatalk
 Making them is the easy bit, its getting the time to do it that’s hard. I’ve not even got a spare minute to do my own stuff 
102
« on: May 14, 2020, 07:04:20 PM »
I started my clocks. I had to destroy the black knob taking it off. It was suggested that toothpaste top, filled and blacked could be a good substitute.
I ended up making one for mine after destroying the plastic 1  
103
« on: May 02, 2020, 02:18:07 PM »
Why? And I thought that Hayabusa that Dell boy is building on YouTube was bad
104
« on: April 30, 2020, 07:24:10 PM »
Thanks again, you’ll all be fed up of me by the time I get this bike back together 
105
« on: April 30, 2020, 07:09:20 PM »
Thanks for the replies, hopefully thats all they are but its a uk bike, unless its had a loom change in its chequered past
|
Show Posts