Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - sim2011

Pages: [1]

CB750 / Ultrasonic Carb Cleaning

« on: July 11, 2010, 04:05:07 PM »

Just thought I'd let everyone know that I have just purchased a proffesional Utrasonic tank so if any of you local to me want your carbs cleaning then I will do a set of 4 for

CB750 / CB750 K3 Oil leak

« on: July 10, 2010, 11:41:55 PM »

Nightmare !
Just finished my restoration, started engine again for the second time only to notice oil oozing out of the LH side head gasket joint, I cant believe it , it had new gaskets and new O rings the correct Honda ones and a pattern head gasket from Dave Silver.

so its engine out again GRR , no doubt on strip down I will find where its leaking , I'll probably get the barrels and head skimmed to be sure , this time round I've opted for the genuine Honda head gasket at

CB750 / CB750 K3 Fuel line routing

« on: June 19, 2010, 05:36:36 PM »

Hi I know this might be a stupid question but do both fuel lines drop down towards the float bowl or upwards , before joining the fuel tap ?

Bike is CB750K3

CB750 / Wanted CB750 k0-k6 Carb body HELP

« on: May 05, 2010, 08:52:56 PM »

Just stripped down my K3 carbs only to find that some idiot has broken one of the mounting posts for the carb float pin , if anyone has a sscrap set or one body I woul be willing to purchase them , or any one else got any other ideas how to fix this problem.
Thanks
Simon

CB750 / CB750 K3 Right Hand switch Help wanted

« on: May 02, 2010, 10:55:31 PM »

Hi been restoring my switches over the bank holiday weekend, however the knob on the ON-OFF switch on the right hand switch is missing , has anyone got any ideas where I can get one I have posted a pic of the lever just in case anyone recognises its sahpe from another Honda switch.
Thanks
Simon

CB750 / Plug caps for CB750 K3

« on: April 06, 2010, 10:40:50 PM »

Hi Everyone
Just trying to do a bit of shopping for my CB750K3 before it arrives.
I'm going to replace the plug caps with black NGK 5 ohm resitor ones and then run it with NGK D8EVX plugs, can anyone tell me the corrcet NGK caps to use for this model.

Anyone else used D8EVX plugs ?

Thanks

Simon 750K3

CB750 / Engine case paint

« on: April 05, 2010, 08:20:09 AM »

Hi everyone
Has any one used this paint on their barrells head and casings ? SIMONIZ VHT SILVER SPRAY PAINT RATED TO 650 degrees C , 1200 degrees F , if so
A/ is the colour right ?
B/ is it any good ?
Thanks
Simon CB750K3

New Member Introductions / Hi Everyone

« on: April 04, 2010, 09:21:59 AM »

Hi Just bought a low lileage 750K3 , inteand to ride this summer then strip down and repaint engine etc. I had an F1 back in 1980 ish I will try and get some images of it posted (currently on negs)