Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - remcoseegers

Pages: [1]
1
New Member Introductions / Re: Hello from Barcelona
« on: February 02, 2020, 04:39:29 PM »
Welcome. We have another forum member from Spain, Madrid. He is one of our forum sponsors. His name is Diego but we know him as Piki from Redice decals.

I know Diego :-) we already had some contact!

2
New Member Introductions / Hello from Barcelona - Now with some pictures
« on: February 02, 2020, 01:35:32 PM »
Hello everybody,

My location is (very close to) Barcelona, Catalunya. I am from The Netherlands and owner since a couple of years of a 500 K0 from England, it was imported. I made a couple of changes, I am sure not everyone agrees on it but it is how I like it. I needed the KM clock instead of miles so that was changed to a K2 set. Then, a Giuliari seat was installed but I prefer original. I prefer the K2 look of the seat, I found a very good one, complete with the document lid etc but needs a new cover. I changed the locking system also to K2 as the original mount plate & lock was not very original neither anymore. Then, I was lucky and found some original exhausts. That made me happy. The open 4-1 is available if anybody is interested. Several other things were changed to make it look nice.

First some pictures how it was a couple of weeks ago. I installed the new exhausts but it was not running good enough. Last year I already did the carbs but now I took the top end complete apart. I had several carb parts plated. I found some new NOS pistons as 1 had a serious problem. New piston rings etc etc. Cilinder head needs some work, 5 or 6 M6 are gone, valve cover has one corner broken. All will be fixed. Now I have a new issue, one of the coils has the ground wire broken and I think the other coil was already fixed sometimes. So, searching for 2 new coils. I need them to be the about 5 to 6 Ohm because of the electronic ignition.

I made some piston plates to make cilinder install easier. I hope it is not giving me too many headaches upon install. Any tips?
At the end a pic of the 4-1 exhaust, very good for a cafe racer. Needs one simple hole below to be closed but that is easy to do. If somebody wants them, let me know.

Also you can see the seat I bought, very good shape, just need a new cover, working on that right now :-)

Well, so much for now :-)

[img width= height= alt=IMG-3268" border="0]https://i.ibb.co/ncN25Mm/IMG-3268.jpg[/img]
IMG-3954" border="0
IMG-4082" border="0
[img width= height= alt=IMG-4116" border="0]https://i.ibb.co/yfgg23M/IMG-4116.jpg[/img]
[img width= height= alt=IMG-4115" border="0]https://i.ibb.co/KGF9dxT/IMG-4115.jpg[/img]
IMG-4162" border="0
[img width= height= alt=IMG-4163" border="0]https://i.ibb.co/16pHPJw/IMG-4163.jpg[/img]
[img width= height= alt=IMG-4232" border="0]https://i.ibb.co/TKnmZyG/IMG-4232.jpg[/img]
IMG-4235" border="0

Pages: [1]
SimplePortal 2.3.5 © 2008-2012, SimplePortal