This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Colonial-Clive (yindi)
Pages: 1 2 3 [4] 5 6 ... 15
46
« on: September 02, 2018, 01:12:39 PM »
I have twin discs on mine I used original master cylinder worked but not very well bought fancy race bike one worse than original then got gl from DSs and now stops on a sixpence!
PS I also updated to braided hoses.
47
« on: August 06, 2018, 07:18:28 PM »
I put Barnet plates and updated springs in no slip only have to break them free before starting when stood for a while.
48
« on: July 22, 2018, 05:40:54 PM »
Bad earth on coil maybe, Look at your bullet connectors make sure there not all corroded up.
49
« on: June 26, 2018, 10:34:03 AM »
These guys are really good and know there stuff there in Oz so postage isn’t the killer like the Americans are! https://www.japbikespares.com
50
« on: June 13, 2018, 10:23:37 AM »
Yep mine sounds like an empty can of bolts at the moment just saving the pennies to take it too These guys. http://d-mengineering.co.uk They can fine tune it, then it's time to put the smiles with the miles on!
51
« on: June 13, 2018, 10:19:20 AM »
Mines not stock but it's better than that imo, and I've parted with that much moola to DS to! So can I get 10k? Only if there's a fool in the room!
52
« on: June 12, 2018, 08:17:13 PM »
Hi, well I just com across this on eBay 163086263151 cb500/4. Will need to get the tissues out!
53
« on: June 12, 2018, 08:07:34 PM »
That's a bugger I'm on a flight to Thailand that day!
54
« on: June 07, 2018, 09:25:17 AM »
Envious of your moving to Oz lived there for 30 years and all my family there, but Brisbain really is not biker friendly any more than 3 in a Group and you get bounced by the police. They call it anti-consorting laws!
55
« on: May 16, 2018, 11:16:25 AM »
You could try D&M engineering, worth looking at there website mental 500/4 race bike builders. They are based near Newark
56
« on: April 29, 2018, 01:45:47 PM »
I got gerban to do full refurb £200 inc return post look like new and bench set, best thing I did.
57
« on: April 29, 2018, 10:54:04 AM »
You say you've refurbed carbs, have you had them synced, my bike sounds like a tractor at the moment and the only thing I haven't don't is carb sync.
58
« on: April 24, 2018, 12:30:25 PM »
I was told basically the same thing but to call them again once it came into practice, as they would know for sure the legal requirements.
59
« on: April 05, 2018, 01:24:20 PM »
Loads on the bay. Just don't get plastic!
60
« on: March 30, 2018, 07:15:50 PM »
Hi, from front bolt to tyre is 6", from no 2&3 pipes 5" so you should have enough room, or you could rake the neck a tad.. 
Pages: 1 2 3 [4] 5 6 ... 15
|
Show Posts