Recent Posts

Pages: 1 [2] 3 4 ... 10
11
CB500/550 / Re: Side stand too close to the number one front pipe issue ?
« Last post by Seabeowner on Today at 06:30:45 PM »
I had the same problem with my 4/4 set from silvers. It would clang on the pipe coming up.
Bit of a bodge,  but I stuck a tiny piece of 1/8" rubber against the stop.
Phil
12
CB350/400 / Re: rotor removal tool. Also Gaskets
« Last post by McCabe-Thiele (Ted) on Today at 06:24:31 PM »
I would also add you can get corrosion in the output connection block as well as where it leaves the alternator housing.
13
CB350/400 / Re: rotor removal tool. Also Gaskets
« Last post by Jan B on Today at 06:10:13 PM »
Did you check the ohm-readings on the 3 stator wires? That will tell you something. The regulator is more likely to fail...
14
CB500/550 / Re: What is the correct 500 rear brake light switch wiring route ?
« Last post by McCabe-Thiele (Ted) on Today at 05:30:10 PM »
Thanks for that.👍
15
CB500/550 / Re: Relocating or alternative to ignition switch
« Last post by Laverdaroo on Today at 05:30:04 PM »
No worries bud, just shout Dom


Sent from my iPhone using Tapatalk
16
CB500/550 / Re: Relocating or alternative to ignition switch
« Last post by DomP on Today at 05:27:16 PM »
Quote from: Laverdaroo on Today at 04:54:22 PM
I know where there might be some brackets but they’re in the US.

Do you want me to ask my pal over there Dom? It’s a bit of a long shot but I know they’re there……



Sent from my iPhone using Tapatalk

Don't worry Roo, I'll cobble something up on the cheap if I can, failing that I'll take you up on your kind offer mate
17
CB500/550 / Re: What is the correct 500 rear brake light switch wiring route ?
« Last post by ozzybud on Today at 05:18:23 PM »
Here is my unmolested CB550. Plugs in behind the frame bar
18
CB500/550 / What is the correct 500 rear brake light switch wiring route ?
« Last post by McCabe-Thiele (Ted) on Today at 05:01:40 PM »
I can't seem to see the best route for the brake lamp switch wiring here is my photo.
Not sure if this would interfere with the fitting of the side panel.

Does anyone have a photo of the correct wiring route?


The cable tie is temporary, iginition currently disconnected whilst I'm doing the static timing.



.PXL_20240514_154010749 by Macabe Thiele, on Flickr
19
CB500/550 / Re: Relocating or alternative to ignition switch
« Last post by Laverdaroo on Today at 04:54:22 PM »
I know where there might be some brackets but they’re in the US.

Do you want me to ask my pal over there Dom? It’s a bit of a long shot but I know they’re there……


Sent from my iPhone using Tapatalk
20
CB500/550 / Re: Relocating or alternative to ignition switch
« Last post by Laverdaroo on Today at 04:52:54 PM »
Sorry to hear that Bryan, best wishes mate.


Sent from my iPhone using Tapatalk
Pages: 1 [2] 3 4 ... 10
SimplePortal 2.3.5 © 2008-2012, SimplePortal