Honda-SOHC
SOHC.co.uk Forums => CB350/400 => Topic started by: 4wDaz on April 29, 2020, 02:11:27 PM
-
Hi guys I’m currently putting a bike together that I didn’t strip down and need a bit of help regarding the handlebar wiring route and how the two bundles of wires run when they exits the hole in the middle of the handlebars, I’ve tried to look at pictures online but some run the pair of wires to the left hand side of the ignition switch and some split them and run one to the left and one to the right. Id like to run them as the factory did so if anyone can offer any help it would be appreciated, thanks Daz :)
-
This should help.
-
After they come out of the handlebar hole, both then go over the top frame tube, go around by the left hand tank rubber, there should be a clip to hold them.
-
So one to the left and one to the right of the ignition switch then. Thanks very much :)
-
Yes. This may be a bit clearer.
-
Perfect thanks again :)