Honda-SOHC
SOHC.co.uk Forums => CB750 => Topic started by: philward on January 20, 2024, 04:48:40 PM
-
Can anyone please advise off the rotor puller size/thread please. Need it off to replace the starter clutch as it slips occasionally. I have a R/H M20 x 1.5 bolt that I'm sure I've used this before but it won't start to screw in
Cheers
-
I use a Fiat Ducato Van wheel bolt. Dirt cheap on ebay
M14x1.5
https://www.ebay.co.uk/itm/134149268605
-
Defo not m14 Ash as 18mm bolt is loose in the hole. Think its the end of M20 bolt thats nackered - tried filing bolt end but no luck. Don't want to force in case I knacker the rotor thread
-
How urgent is this Phil?
I can bring over my genuine Honda rotor puller when I pop over if that helps, missus is still pretty poorly so not sure when that will be but maybe next week if that's ok.
-
Thanks Ken but probably difficult to juggle a time thats convenient for us both as I am at Christie's in Manchester for radiotherapy (different times every day Monday to Friday) and Hyperberic Oxygen treatment (alternative supporting therapy) each day in Chorley in the other part of the day - so most of each day taken up battling this b*****d tumor!
Wait until your wifes better - parts arn't going anywhere so you can pick them up after she's better
I'll order a puller off eBay so probably won't work on it until next weekend
-
Sorry Phil .. the M14 must be for the CB250/350
According to what I read on internet it's M20x1.5
-
Thanks Ash, I'll see if I can clean up the threads and if it doesn't work 'I'll order one off eBay
-
Can't remember if it's 750 but I did once use a rear axle to remove one. Fitted perfectly but no idea what the thread size was. I was just trying everything I had to hand that day.
Sent from my Pixel 7 Pro using Tapatalk
-
Can't remember if it's 750 but I did once use a rear axle to remove one. Fitted perfectly but no idea what the thread size was. I was just trying everything I had to hand that day.
Sent from my Pixel 7 Pro using Tapatalk
Tried that but it's too small Roy
Sent from my moto g(50) using Tapatalk
-
Read somewhere an that oil filter bolt fits ... not so sure myself
-
Honda tool no 07933-000000 20x1.5 bolt