This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - neat street
1
« on: Today at 08:57:05 AM »
to be clearer, its the front ones part No 90034-323-005 (approx 13cm long), these are a little shorter than the rear ones :-)
thank you
2
« on: May 25, 2024, 10:08:00 AM »
Hi all, I am after 2 x cylinder studs for my CB500 and can`t find any anywhere? does anyone know of or has a couple that they would sell please.
#thank you
3
« on: May 24, 2024, 07:35:16 AM »
thank you all for your help, really appreciate your comments
thank you
4
« on: May 11, 2024, 08:07:22 AM »
Thank you Dave, this has helped alot :-)
5
« on: May 10, 2024, 03:25:00 PM »
thank you Johnny, the old gasket is completely damaged beyond measurement, had to scrap off, but thank you for the tip
6
« on: May 06, 2024, 08:30:06 AM »
It depends which gasket set you use as to the size O rings you will need. All the kits have different depth head gaskets.
Thank you nurse Julie any adea on the difference I should be looking for from gasket thicknes to `O ring`? or how would you work out what size would be best to use? thank you again
7
« on: May 06, 2024, 08:26:53 AM »
I have a local source for most O rings
A company called Hayley Group
On a local industrial estate, the Hereford branch are really helpful,
Imperial, metric,fuel resistant etc,
And the bonus, normally a fraction of the cost of NOS,
Take a sample, and the item, like tappet cap ,they will find the size needed
Sent from my SM-A546E using Tapatalk
Thank you John Great tip and advise :-)
8
« on: May 05, 2024, 07:52:55 AM »
Thanks Brian, good to know and will have saved some headaches later. :-)
9
« on: May 04, 2024, 10:11:12 AM »
thanks John, :-)
10
« on: May 04, 2024, 10:03:39 AM »
Hi All
not been on for a while, now have a CB500 1973 to go with the 750, and taking top end down. could anyone please recomend a top end gasket set? (hopefully complete) :-)
thank you
John
11
« on: April 28, 2024, 08:58:12 AM »
done
12
« on: March 16, 2024, 09:39:33 AM »
750
13
« on: November 19, 2023, 10:01:48 AM »
so sorry to hear the new Phil, the treatment will take time, but we all wish you well and keep posting :-)
14
« on: April 26, 2023, 07:10:38 AM »
Thanks Odd job and Brian. appreciate your help and replies :-)
15
« on: April 25, 2023, 04:30:19 PM »
did you go for the OEM or the copy?? I will need to get one as well soon.
|
Show Posts