9931
CB750 / Re: 750 K2 Rebuild
« on: February 04, 2009, 03:08:10 PM »
If you look arround the thread edge of the screwed in retainer you will see 4 points where it looks like somebody used a centre punch. you need to dill down with a 1/8 drill (ish) till you have removed the deformed metal to allow the retainer to unscrew.
Now i seem to remember that one of them is a L/H thread and i think its the rear---but dont take that as gospel as its been a LONG time.
Dont think much of your chromer if he has done a hub complete with bearing and grease in it!!
Now i seem to remember that one of them is a L/H thread and i think its the rear---but dont take that as gospel as its been a LONG time.
Dont think much of your chromer if he has done a hub complete with bearing and grease in it!!