This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - SteveW
1
« on: Today at 10:28:18 PM »
You don't use the felt with the bronze bushes, just the end cap.
Thanks Julie 👍
2
« on: Today at 08:45:26 PM »
Mine had the felt seals, I don’t need them do I?
3
« on: Today at 06:59:13 PM »
Yes you do Steve. They are dust seals and they also have a rubber seal on the inside to keep the swing arm grease in.
Thanks Dave.
4
« on: Today at 05:39:42 PM »
I have a set of the bronze bushes from Julie I’m about to install.
Do I still need the caps, item 15 in the picture?
5
« on: May 01, 2024, 06:08:09 PM »
I heated the end of the swingarm and just knocked out the bush with a long steel rod. Came out pretty easy, no cutting.
Are you refering to the short bushes that used to be plastic (Julies are Brass) or the long Center Collar shown in the parts book diagram as item 13 p/n 52141-300-000 a hefty £103.22 from DS?
They were about 2 inches long and definitely metal.
6
« on: May 01, 2024, 01:22:25 PM »
I heated the end of the swingarm and just knocked out the bush with a long steel rod. Came out pretty easy, no cutting.
7
« on: April 19, 2024, 02:02:10 PM »
Try H & R insurance in Aberdeen, I found them very good when I used to have my 1994 BMW M3.
8
« on: April 13, 2024, 05:02:15 PM »
That would be great. I’ll send you a PM.
9
« on: April 12, 2024, 04:25:33 PM »
Threads are butchered, not by me.
10
« on: April 12, 2024, 12:33:44 PM »
Need just the front part of a 550 brake caliper housing if anyone has one. Don’t need the internals just the main housing the piston fits in.
Thanks.
11
« on: March 31, 2024, 03:53:39 PM »
The 2 pin connectors on the Oximizers are rubbish. I’ve had my Fireblade on trickle charge for the last 6 months and didn’t realise there was a bad connection on it so it didn’t maintain the battery.
Now I have a battery that’s dead and won’t charge because the bike alarm has drained it completely.
I’ve re wired the Oximizer with the parts from Amazon below, cable on the left just cut one end off and soldered it the the Oximizer pcb.
Way better connection.
12
« on: March 30, 2024, 06:22:57 AM »
13
« on: March 28, 2024, 11:21:12 PM »
Thanks for the info 
14
« on: March 28, 2024, 08:15:18 PM »
Not sure yet, seen them on Amazon but may look elsewhere.
15
« on: March 28, 2024, 07:20:20 PM »
Has anyone used the 2K rattle cans where you press the valve in the bottom to add the activator?
Was thinking about using them on my 550 frame.
|
Show Posts