Recent Posts

Pages: 1 2 3 [4] 5 6 ... 10
31
Out & About / Re: OUT AND ABOUT 2024
« Last post by taysidedragon on Today at 11:50:54 AM »
There were some beauties at my local bike meet on Wednesday. Shame about the jacket draped over the Duke.

32
SOHC Singles & Twins / Re: CB360 Wiring question
« Last post by Craizeehair on Today at 11:29:02 AM »
Thanks all, I will have to give it a good looking at over the weekend, along with a good dose of head scratching. I was hoping someone would say that they are surplus to requirement, not needed, unused and ignore them
33
SOHC Singles & Twins / Re: CB360 Wiring question
« Last post by McCabe-Thiele (Ted) on Today at 10:59:00 AM »
Brake pressure switch?
34
Desperately Seeking!! / Re: CB400 Rear Brake Rod 43451-377-000
« Last post by Deano400 on Today at 10:58:41 AM »
Thanks Dave, will take a look.
35
SOHC Singles & Twins / Re: CB360 Wiring question
« Last post by AndyD on Today at 09:44:42 AM »
I think that light green / red is used for neutral switch / light on the CJ models so maybe that somehow?
I also seem to remember that there were one or two unused wires somewhere on the CJ loom but can't recall where.

Cheers,
Andy
36
CB350/400 / Re: Anyone recognise this bit?
« Last post by Laverdaroo on Today at 01:10:24 AM »
You legend, cheers for that. I actually thought they were fixed in the cap or part of it. Never knew they came out at all. Brill, that’s a great result


Sent from my iPhone using Tapatalk
37
CB500/550 / Re: Rear wheel rotation stiffens up when tightening axle problem.
« Last post by McCabe-Thiele (Ted) on Today at 01:00:47 AM »
It's probably  between my ears rather than reality - when I did my rectification fit of the right bearing instead of using my lump hammer as previously to get it fully home -  I used my Orange Plastic shot filled hammer for the final strike - thinking it might stop a rebound.
38
CB350/400 / Re: Anyone recognise this bit?
« Last post by McCabe-Thiele (Ted) on Today at 12:33:03 AM »
Well spotted Ozzybud  I did not realise they come out!

Knowing your luck Roo it will be the last one you check that's missing!
39
Project Board / Re: Teds new project a CB500 K1 mostly version 0.5 circa 1972.
« Last post by McCabe-Thiele (Ted) on Today at 12:24:20 AM »
Yes they are already painted in gloss Black in safe storage - done by the bloke in Ilkeston who was recommended to me by a sohc member (Seaman Phil?).

No petrol tap or filler cap fitted as yet - I have a tap kit & new filler cap to fit.
All the big ticket items purchased just some minor oddments for the final fettle.
40
Project Board / Re: Teds new project a CB500 K1 mostly version 0.5 circa 1972.
« Last post by magpie114 on Today at 12:16:15 AM »
Looking very good, can’t be too far off. Are the tank and panels finished?


Sent from my iPhone using Tapatalk
Pages: 1 2 3 [4] 5 6 ... 10
SimplePortal 2.3.5 © 2008-2012, SimplePortal