This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Dave1234
16
« on: August 17, 2016, 04:53:24 PM »
Ok, cheers Pete, I am new to this site.
17
« on: August 17, 2016, 04:43:58 PM »
When I send a pm to someone, how do I read them again if I want to. It dosen't seem to save in the sent box?
Dave
18
« on: August 16, 2016, 07:43:03 PM »
Are HEL brakehoses a good make?
19
« on: August 15, 2016, 10:37:11 AM »
Where you get them from Florence?
20
« on: August 14, 2016, 03:44:24 PM »
Thanks Mr T, does that mean you by-passed the stop switch or am I being stupid?
21
« on: August 14, 2016, 02:38:40 PM »
Also do the braided hoses go all the way to the caliper so you don't need to use the copper brake pipe?
22
« on: August 14, 2016, 02:34:28 PM »
Hi all, thinking of changing the front brake hoses on the good old 550k3 for braided ones. So obvious question is what are the best ones to buy and from where? It is good to get others people thoughts before I buy.Cheers in advance for any replies.
23
« on: May 18, 2016, 07:48:43 PM »
Okay cheers Alan, next question where do I find the compression tool?
So if it is compressed on and the rivets rounded over (preened) what happens when you want to take the wheel out again (say if you get a puncture) and need to take the chain off.
24
« on: May 18, 2016, 07:29:53 PM »
Hi all, just brought a new DID chain and JT sprockets for the 550, question is the chain dosen't have the old u shape clip, it comes with four o rings. Is this now a compression joint? If so what do you compress it with.
25
« on: May 08, 2016, 08:23:38 AM »
Peter James every time, my 550 and another bike is £80 per year.
26
« on: March 28, 2016, 07:50:34 PM »
Thank you all for your help, I quite like the ones ST1100 has put a link to, as I do have other sets of gauges.
No doubt I be asking other questions soon.
Dave
27
« on: March 28, 2016, 09:24:59 AM »
Sorry, I have forgot to mention I was after an offset set.
Cheers
28
« on: March 28, 2016, 09:12:28 AM »
Hi, new here.
It is probably me or my eye sight but I am looking for a set of feeler gauges to set my tappets on my newly purchased 550 K3.
I can't seem to find a set that covers 0.05mm and 0.08mm
Is it me just being stupid? I shall go and have another look.
Bye
Dave
|
Show Posts