This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Trigger
Pages: 1 ... 429 430 [431] 432 433 ... 498
6451
« on: September 01, 2014, 08:39:13 AM »
This seller sold a second hand fuse box at 3 times the price of what i pay for them new. There was a fuse box lid for a 400 going for stupid money last week.
6452
« on: September 01, 2014, 08:35:58 AM »
Cheers Bryan, I remember the plate's that had the numbers stamped from back. Most of these have been US imports. And i was wondering why i could not find the rivet holes on this frame. Thanks for the info mate.
6453
« on: August 31, 2014, 09:49:01 PM »
Left is your left hand as you sit on the bike. I have a good left fork case when you are requiring a right one. Am i right?
6454
« on: August 31, 2014, 09:44:37 PM »
Bitsa, this is not oil drips. It's spit's of oil.
6455
« on: August 31, 2014, 09:17:36 PM »
Does not look like a gasket problem. Have you re-built the engine 2k miles ago? Mick is on the right line with this but, quarter of a pint is a little too much. Any oily parts round the down pipes or burning any oil?
6456
« on: August 31, 2014, 04:08:40 PM »
give it a couple of paracetamol and tell it to come back in a week if there is no change  .
6457
« on: August 31, 2014, 03:17:00 PM »
Cheers Bryan. My microfiche for a UK 1971 shows a vin plate. We use the same French guy Bryan.
6458
« on: August 31, 2014, 09:15:29 AM »
Need a little help. I am putting a VIN plate on a CB500 Four but, do not know what type of plate they had. Could someone that has a UK 500 please post a picture of there VIN plate or send a picture to my e-mail. Thank you 
6459
« on: August 30, 2014, 04:16:26 PM »
Just had a look in the store and I have a left fork case in good condition if you require one. The right one had a snapped bolt that someone made a mess of trying to drill out.
6460
« on: August 30, 2014, 02:04:32 AM »
Still awaiting my FREE brake pipes Paul
6461
« on: August 29, 2014, 11:42:36 PM »
If you cut it, you will always see the join. I just use a piston ring clamp and a small pin hammer to panel beat it back into place.
6462
« on: August 29, 2014, 08:00:55 AM »
You are listing products without any prices 
6463
« on: August 29, 2014, 07:59:14 AM »
The Man that has used it has spoke. I would never use any chemical sealer and would opt for a different tank but, Norniron would not listen.
One of the best sealers on the market is Flowliner which is used by many pro restorers.
6464
« on: August 28, 2014, 08:55:46 PM »
6465
« on: August 28, 2014, 08:23:13 PM »
Folks can be re-chromed and come out like new.
Pages: 1 ... 429 430 [431] 432 433 ... 498
|
Show Posts