This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Topics - boilermaker1
16
« on: December 03, 2014, 12:40:49 PM »
Hi, Here are some photo's I received from a guy selling a duel disc setup that is on a 400 f . He said that this was an after market setup that was sold by D.I.D. I have never heard of a duel setup that was available off the shelf. any ideas?
17
« on: November 29, 2014, 06:06:47 PM »
Hi, Looking for advise again. does the oil pressure switch tread all the ways down? Is there a seal for between switch and the oil pump? My switch seem to take a lot of pressure to screw down, do not want to shear it Any advise , ideas would be helpful.
Thanks
18
« on: November 05, 2014, 10:39:54 AM »
Hello, Hoping for some advise again. the bearing in my clutch release plate is not great, it does not turn as freely as I think it should..Is it possible to press the bearing out and get a replacement Honda or an aftermarket bearing supplier?
Thanks
19
« on: October 22, 2014, 10:54:56 AM »
Hi does anyone have the torque specs for a 400f head? and what order are they tightened in? Thanks
20
« on: September 02, 2014, 02:33:03 PM »
Hi. My old fuel pipe and overflow pipes are hard and brittle Anyone know of suitable pipe to replace them with? Thanks
21
« on: August 08, 2014, 09:42:47 PM »
Hi. Finally time to start putting my 1975 400 f back together, Hoping someone has a diagram of the proper way the wiring loom fits on the frame. any help would be great
Thanks
22
« on: December 01, 2013, 07:51:54 PM »
Hi, I am restoring /tidying up my old 400 Four. Bike is low mileage and engine runs very well. I want to paint engine but do want to strip it down, Engine is out of frame and sealed so was thinking of either getting it soda blasted or vapour blasted. Has any one painted their engine with out taking it apart and got good results. View comments greatly appreciated.
23
« on: February 18, 2013, 01:26:04 PM »
Hi, I am currently restoring my 1975 CB400 F. I want to paint the engine but have no experience with painting.. I need to know what paint gives a good finish, What prep work needs to be done etc, Any help would be great
|