1
« Last post by Orcade-Ian on Today at 08:02:06 AM »
Great to see and hear it running again Johnny - how many years dormant? Will that be yet another of your exhibits at this year's shows? A nice board with all that Orkney history alongside would be very welcome - at Dounby Show too.
Ian
2
« Last post by Johnny4428 on Today at 06:53:48 AM »
Yes Bryan you did say!🤭 Good tip regarding fuel tank posting as well.
3
« Last post by MCTID on May 02, 2024, 10:49:41 PM »
Tip. Never state that the part you are buying/ sending is a Fuel/ Petrol Tank !
Just note it as 'Motorcycle Parts'.....I have sold/ sent a few Tanks over the years and never had any problem when using that description - which is the truth anyway.
Of course the Tanks I have sold/ shipped have not held any Petrol for years and have been well 'aired' so they are basically just lumps of steel plate so there is no risk.
4
« Last post by SteveW on May 02, 2024, 10:28:18 PM »
You don't use the felt with the bronze bushes, just the end cap.
Thanks Julie 👍
5
« Last post by Bryanj on May 02, 2024, 10:18:51 PM »
There you go, told you it would be ok!
6
« Last post by Nurse Julie on May 02, 2024, 10:00:53 PM »
Old bushes knocked out today. They were as Julie described: a sort of Bakelite material, definitely not metal. I concocted a tool to knock them out made of a length of M10 studding. Worked a treat. When it comes time to put the arm back in the frame I’m probably going to need some help. Looking at the parts diagram I don’t recall there being that many spacers and washers etc when I took it apart. Everything that came off was bagged up however,
.
On yours Mike, referring to the fiché picture, you only fit the new bronze bushes and the end cap.
7
« Last post by Orcade-Ian on May 02, 2024, 09:42:28 PM »
I managed to do a workaround for today's pics. I emailed them to myself and had the choice of keeping original size or reducing when attaching. Picked reduce, then saved them to photos and they were about 1Mb, down from 4.1.
Apologies to Steve, perhaps best not to increase permitted size - the 'slack' might be needed for something else.
Ian
8
Old bushes knocked out today. They were as Julie described: a sort of Bakelite material, definitely not metal. I concocted a tool to knock them out made of a length of M10 studding. Worked a treat. When it comes time to put the arm back in the frame I’m probably going to need some help. Looking at the parts diagram I don’t recall there being that many spacers and washers etc when I took it apart. Everything that came off was bagged up however,
.
9
« Last post by Orcade-Ian on May 02, 2024, 09:30:55 PM »
We'll do our best John - was quite warm but still had a choppy wind.
Ian
10
Dave, its only the later ones with a rubber seal, early ones the seal is the felt ring, i think i still used the caps with the bronze bushings though
I've been hanging around 400/4’s for too long Bryan, I thought looking at the parts diagram the end caps were the same as those on a 400. Every day is a school day on the forum👍
|
Recent Posts