Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - CBNelly

Pages: [1]
1
CB350/400 / 400/4 Starter Motor Pics
« on: September 11, 2022, 03:34:52 PM »
Hi, does anyone have any photos (or schematics) of the inside of a 400/4 starter motor where the power cable bolt connects to the windings?
My through bolt is loose and turns when I tighten the nut on the outside
Starter motor works but the windings only rest against the through bolt (not soldered)
Should there be nuts both side of the casing to hold the bolt/stud securely?
Thanks!

2
CB350/400 / advance/retard unit
« on: May 28, 2022, 12:47:18 PM »
Hello Everyone
Enjoying working on my 400/4 in the sun setting up the carbs and timing
I've had the advance/retard unit in bits and now back together and on the bike
However I've come across a 0.1mm thick shim (23mm OD x 15mm ID) on my workbench and wondered if I missed during the reassembly
Does anyone have a photo breakdown of the unit?
Thanks

3
CB350/400 / Poor Cold Starting
« on: July 24, 2019, 10:33:30 PM »
Hi,
Have owned my 400/4 since 1990 and always been a good starter
That was until I totally stripped down the carb assembly!
Now takes ages to get going normally with throttle opened
When started it runs fine
Seems like the choke is not working even though butterflys close and tops lift when apply choke
What should I be looking for on carb set-up?
Carbs currently sat on my work bench and all checks so far have yielded nothing
Help
Thanks
Neil

4
CB350/400 / Fitting Airbox
« on: October 01, 2018, 10:23:36 PM »
After struggling (again) to fit the airbox to my CB400F I wondered if anyone has a fitting technique that works?

Had my bike nearly 30 years now and I dread every time I get to this part of the re-assembly!!

Thanks!

Pages: [1]
SimplePortal 2.3.5 © 2008-2012, SimplePortal