Honda-SOHC

I am having a problem posting pictures, when i attach them when i try to post an error message says my session has timed out, even though it has only been a minute. when i try to repost my pictures disappear altogether. Help please!

I am in the process of polishing my engine covers which job i have done before and got acceptable results, until i saw Oddjobs standard! My trouble is removing the scratches before polishing, i have tried different methods but unless i spend hours with wet or dry paper they remain to taunt me. Lots of tips have been posted but when you need them its hard to remember who or where, and i dont have much luck with the search facility. Would a thread to put everything together help us mortals to soak in the knowledge of the polishing gurus.

Due to lack of use and needing funds for my other project i have decided to sell my 550 f2. It is in decent condition having had lots of money spent over the last few years, see my thread meet my new 550. It has had rebore and valve guides/ head refurb by Trigger, just about run in now, i will do a oil and filter change soon. There are still some areas to improve, the paint on the tank is not great, but would not embarrass you at a bike meet and has the usual honda clutch rattle at tickover. I would like £3,500 for it or near offer, PM me if you want any more details.

I have one of these from a job lot of 500 parts i bought. It is the bearing retainer for the rear wheel bearing and seems to fit all the 250/350 k0-k4 models. Honda part nos 41231 286 000 in honda bag but a bit tarnished. Anyone who wants it can have it for free as no use to me.

Had a morning off today so thought i would take my 550f2 for a cheeky spin, the first outing this year! so checked the tyres etc and started it up, but only fired on 3 cyls, no 3 not sparking. of course its awkward to remove but tried it on the side of the engine and sure enough dead as a dodo. Ok so plugs do wear out but i have had this problem before with my 500/550 bikes, where after being stood for a while and even if it was running fine when last used, one plug decides not to play. I always use NGK and have very few miles on them so what is the answer, do i change brand?

Hi i have some parts for zinc plating, carb parts and bolts etc. I have read some old posts but i am unsure how to prepare for the replating, do i need to strip the old plate or will the plating firm do it? i am not keen on chemical mixing like Ash suggests so up to now i am just wire brushing to a clean surface.

Due to popular demand i have called my 500 four "Lazarus". As some of you have seen in my other posts it was in very poor condition, many parts are past any hope, the engine is seized so not a great start. Originally i was going to leave it for a later date but decided to strip it down to better store it. well that poor bike had been horribly abused in the past so i feel it is my duty to bring Lazarus back to life. It will need all the usual stuff, engine and wheels rebuilt and lots of replacement parts, and the wiring... well it consisted of lots of odd connections and tape and all of the block connectors had been chopped off. Will need a new wiring loom complete. The first job will be to strip to the frame and get it de rusted and painted, so here we go again!