This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bryanj
1
« on: Today at 10:18:51 PM »
There you go, told you it would be ok!
2
« on: Today at 08:05:44 PM »
Dave, its only the later ones with a rubber seal, early ones the seal is the felt ring, i think i still used the caps with the bronze bushings though
3
« on: Today at 08:04:05 PM »
Only thing i can think off is either something between case and shell or the disaster of a bent crank, i have built engines with all black shells with no rotational problems
4
« on: Today at 08:01:17 PM »
But no hallway ornaments!
5
« on: Today at 01:22:38 PM »
You didnt oil the back of the shell did you?
6
« on: May 01, 2024, 06:45:48 PM »
Sold or pulled
7
« on: May 01, 2024, 05:08:56 PM »
Usually you find the collar more worn than the bushes, the early one is still available, but bloody expensive, the later one is not available but you can use the early one, preferably with the bolt having a grease nipple at each end rather than the one in middle of swing arm
8
« on: May 01, 2024, 05:03:57 PM »
It only says new stainless exhaust NOT original
9
« on: May 01, 2024, 05:00:43 PM »
Boyer fire all the plugs all the time
10
« on: May 01, 2024, 04:59:06 PM »
As my wife suffers from ME what annoys us is the symptoms are VERY similar but ME sufferers get no help at all, long covid seems to be getting lots of help
11
« on: April 29, 2024, 11:36:32 AM »
A lot of us people will not be happy as they are waiting for 750 units
12
« on: April 29, 2024, 11:10:19 AM »
Same system
13
« on: April 28, 2024, 03:46:23 PM »
It never has in all the years i been doing them, BUT i do make sure the nut runs free
14
« on: April 28, 2024, 03:44:46 PM »
Why not? If you can design for whole numbers you can design for half way
15
« on: April 27, 2024, 10:30:19 PM »
You dont ever use the slot anyway, when building before fitting cam stick fingers down tunnel, push slipper to carbs and hold whilst nipping up locknut then just undo when built and holding pressure on kickstart, nipping up whilst holding pressure.
Check the tensioner fold over tabs are crimped over tight to hold theteeth on the bolt in mesh with the rack, people forcing the screw slot in the false idea that this will tension the chain is what damages the meshing in the first place
|
Show Posts