Honda-SOHC

SOHC.co.uk Forums => CB350/400 => Topic started by: 4wDaz on May 17, 2020, 08:12:24 PM

Title: Carb O-Ring Size
Post by: 4wDaz on May 17, 2020, 08:12:24 PM
Hi, Just about to start rebuilding the carbs, does anybody know what size the o rings are for the Tee where the fuel pipe goes on ? Thanks
Title: Re: Carb O-Ring Size
Post by: Nurse Julie on May 17, 2020, 08:18:09 PM
6x2 rings a bell but get someone else to confirm.
Title: Re: Carb O-Ring Size
Post by: Oggie400F on May 17, 2020, 09:28:32 PM
I used 2mm cross section x 5.5mm Viton on mine with no leaks.
Readily available on eBay.
The four rings for the metal fuel inlet tee piece are not included when you get a full set of Keyster kits as I found out recently.
Title: Re: Carb O-Ring Size
Post by: Moorey on May 17, 2020, 10:24:51 PM
6x2 Viton.
Title: Re: Carb O-Ring Size
Post by: 4wDaz on May 18, 2020, 09:25:39 AM
Thanks for the replies, i found some orings which came with the bike which are 1.9mm x 5.8mm in a honda bag which i thought could have been what i needed
SimplePortal 2.3.5 © 2008-2012, SimplePortal