This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - mickharrow
16
« on: June 23, 2015, 01:51:05 AM »
The wheels are comstar and the other stuff is not of any bike in particular but stuff I bought as a job lot so mixed up.not sure what year the headset is or any of the other bits and pieces but worth a look if you are anywhere near ringwood.
17
« on: June 22, 2015, 10:24:05 AM »
having completed my cb ready for the track i have some bits left over which may be of use to someone,they are as follows
pair of wheels,set of carbs,top and bottom steering stem,swinging arm plus a box of bits and pieces.
dont want much for them or will swop for anything usefull
collection from ringwood
18
« on: April 16, 2015, 09:48:19 AM »
Many thanks for your reply but DK cannot help and DSS does not have one so still trying
19
« on: April 15, 2015, 05:22:17 PM »
Has anyone got a rotor set bolt that holds the rotor onto the shaft for sale,need one urgently
20
« on: March 19, 2015, 07:24:13 PM »
The bike I am building uses these collars as it has a non standard exhaust. Have just ordered a pair from dss which will do the job.
Many thanks for your comments and help
Mick
21
« on: March 18, 2015, 06:45:26 PM »
They are for a k2 engine I am fitting into a later frame as a special flat tracker
22
« on: March 17, 2015, 12:10:18 PM »
Has anyone got a pair of split collars that go into the head and are held by the finned collar to enable me to finish my project?
If you have and wish to sell them just advise price with postage and I will happily pay
23
« on: March 04, 2015, 06:49:34 PM »
Thanks for your help
24
« on: March 03, 2015, 12:49:45 PM »
Can anyone tell me the size for the bolts that hold the cover over the ignition on the near side
Thank you
25
« on: February 28, 2015, 08:12:05 PM »
Having read this post I was dreading trying to put on the carb rubbers today on my rebuild. The rubbers were supplied by David silver and went on with a hard push and wiggle so a very happy chappy now.
26
« on: October 29, 2014, 07:56:41 PM »
I am so gratefull to get so much help from this forum it is absolutely first class
I am happy to pay whoever sends the spacer just let. Me know
I have some parts if they are of use to anyone namely a pair of. Komstar wheels,swinging arm,carbs headset,if they are of use to anyone just let. Me know
27
« on: October 29, 2014, 05:35:40 PM »
The one I am looking for is number 9 on the exploded view.i am happy to pay if you have the dimensions to make one up but would suggest you make more than one as they seem unavailable from the usual sources
Regards mick
28
« on: October 29, 2014, 10:33:24 AM »
Has anyone got a rear wheel spacer left hand side they could sell me. This is the straight spacer not the stepped one.none available from usual sources
Thank you
29
« on: July 30, 2014, 10:20:47 AM »
many thanks for your offer of help but i need a full set so will have to go to david silver
30
« on: July 11, 2014, 03:37:39 PM »
Anyone got a set of Cush drive rubbers for a f1 cb750. they want to sell
Thanks
|
Show Posts