This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bryanj
Pages: 1 2 3 [4] 5 6 ... 672
46
« on: April 12, 2024, 06:25:56 PM »
On the pipe union or bleeder, i have repair kits for the bleeder
47
« on: April 12, 2024, 06:25:02 PM »
Points gap and timing first
48
« on: April 12, 2024, 06:24:12 PM »
Eggcup full of parafin wouldve sortrd that! But seriously well done, we just need to hear the running
49
« on: April 12, 2024, 03:34:10 PM »
Dont know why you took it apart, would have run as it was!
50
« on: April 12, 2024, 03:32:03 PM »
400,500,550 all the same mate, whats wrong with yours
51
« on: April 11, 2024, 09:00:38 PM »
I think you are missreading the plastigauge chart or the micrometer ifvit was the gap you say you would probably feel play
52
« on: April 11, 2024, 08:58:32 PM »
The other possibility if ht leads are correct is kinked fuel pipe to 1&2 or a blocked tap outlet to 1&4
53
« on: April 11, 2024, 01:59:58 PM »
Its possible the housing has a small crack due to overtightening the taper thread or it could be the cover plate leaking, nurse julie does O ring kits for the pump
54
« on: April 11, 2024, 01:55:04 PM »
Using a screwdriver usually overtightenes the camchain leading to excessive wear and possible breakage, ifthis is the only way you can doo it then something is broken/siezed and needs fixing
55
« on: April 10, 2024, 11:48:26 PM »
I might be able to use a us contact for you if the rubber is in us
56
« on: April 10, 2024, 07:41:46 PM »
Roo, i have several sets of 500 carbs about and will get some out on saturday for you to borrow mate
57
« on: April 09, 2024, 09:45:45 PM »
As far as i know all the 500 are the same but they do corrode, only place i ever saw them was silver but not cheap. There is a sevice bulletin about clutch adjusters in alladins cave
58
« on: April 09, 2024, 09:43:24 PM »
They are the push in with O rings arnt they mate, if so 100 is atandard 500 so im sure i can find a loner set for you
59
« on: April 09, 2024, 09:42:07 PM »
Not sure if the F2 is there but good parts diagrams at cmsnl just make sure you get the correct model
60
« on: April 09, 2024, 09:40:13 PM »
Never had a problem just knocking them in Ted
Pages: 1 2 3 [4] 5 6 ... 672
|
Show Posts