This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Messages - Bryanj
Pages: 1 ... 441 442 [443] 444 445 ... 673
6631
« on: August 26, 2016, 10:51:39 AM »
That cracked piece is a separate item to the main plate and can be replaced if done carefully
6632
« on: August 26, 2016, 10:49:16 AM »
If you leave it rattling it will eventually wear through the oil galler from pump to filyer and/or the main cross gallery either of which is terminal
6633
« on: August 26, 2016, 10:47:32 AM »
Unfortunately it wasn't the conversion from 8 to 4 shafts that totally cured the wear problem it was the 76 onwards cover where the shafts were locked into the cover by cotter bolts that cured it. Having said that I have only ever seen 2 worn out rocker covers
6634
« on: August 25, 2016, 08:52:25 PM »
distinctly possible the engine is original, from my list the bike was built approx. 8/72
6635
« on: August 24, 2016, 05:01:13 PM »
I seem to remember that on the K3 one rubber was a different angle to the rest But it might have been both outers
6636
« on: August 24, 2016, 09:10:23 AM »
If you have the K3 ones they are rocking horse poo, especially the one that is different. DS sells pattern 500 ones
6637
« on: August 23, 2016, 07:07:50 AM »
There are firms in the US that reprofile cams but don't know of any in the UK. Any 750 cam will fit and run and the power loss will be minimal and almost cetainly un noticable
6638
« on: August 21, 2016, 01:53:58 PM »
No reason why not, put it as hot water as you can stand to get it round the tank curves
6639
« on: August 21, 2016, 10:10:20 AM »
If its the 500 then a standard 7 inch will fit in the honda rim
6640
« on: August 19, 2016, 11:29:16 PM »
Try Heat and plusgas/wd40 at the same time----just be prepared for the flames!!
6641
« on: August 19, 2016, 05:07:01 PM »
I think those are m7 with an 8mm hexagon--DO NOT try and undo one that has been in there for a long time without warming the caliper housing and also use a long socket with a T bar so you don't put uneven stress on the thread
6642
« on: August 19, 2016, 09:56:37 AM »
What bike as they vary
6643
« on: August 19, 2016, 09:56:02 AM »
As I said I don't think the one bulb would be enough, if you fitted a strip of leds facing forwards maybe. That one bulb is designed as a parking light not a running light
6644
« on: August 18, 2016, 03:17:38 PM »
If you mean the sidelight bulb in the headlamp you can put an LED in there but neither it nor the original is bright enough for daylight running
6645
« on: August 18, 2016, 06:25:11 AM »
UK has on/off US doesn't
Pages: 1 ... 441 442 [443] 444 445 ... 673
|
Show Posts