Honda-SOHC
SOHC.co.uk Forums => CB500/550 => Topic started by: Seabeowner on February 26, 2024, 05:07:19 PM
-
Looking for criticism and sources for paint.
I have an old tank that I have de-rusted and filled a few small dents. It is not really worth spending money on a professional finish as it will be another spare. I have sprayed a few bikes, but that was 40 years ago! And fifty years ago I bought a new 500 (my avatar) in candy garnet brown, so that is the colour for this one.
1. Spray with etch primer because that’s what our factory sprayer did first when I was working. Do I need this?
2. Spray with epoxy primer. Final light rub down.
3. Base coat. What do I need?
4. Spray candy garnet brown all over. How much paint do I need. 500ml seems enough.
5. Cure.
6. Mask for black panels at side of tank.
7. Spray black.
8. Cure.
9. Apply striping decals.
10. Spray 2K lacquer. I know it’s nasty stuff.
Intend to use aerosol rattle cans for steps 1, 2, and 10.
Will also do a test piece as I progress to check paint compatibility.
This has been on here before, but looking for sources and recommendations for paint. I only remember RS paint.
Thanks for any info/advice.
-
Just done the tank for Lazarus in black using spray cans, your method seems ok but I might put at least one layer of lacquer before stripes to even the transition between colours and stripe.
-
I would use German made SprayMax 2k gloss rattle can for the clear coat. Expensive but lovely spray pattern and superb finish if you are careful. I always wear my air fed mask with it. Some people use a Gersen disposable mask with it.
-
Thanks for the info Mick and Ash.
Any other sources for the candy paint?
And what about basecoat. Nothing on RS site. I could give them a ring.
-
Well according to RS paints their garnet brown does not require a base coat.
Other sources say UC-16-100 which seems to be cloud silver.
Am considering this on top of their silver.
https://www.ebay.co.uk/itm/284052756978