16
CB350/400 / The Bleeping 400f Air Box - A Tool
« on: May 15, 2022, 01:13:21 PM »
Time to give to the forum, I was looking at posts and videos about getting the air box onto the carbs after the carbs were installed. I tried yesterday, even with my heat gun and failed.
Today I made a tool out of wood and fitted the box very quickly.
Here are a few photos of what I made.
Oval shape, using the metal link part that goes into the airbox as a pattern.
[ Guests cannot view attachments ]
It is one and a half inch thick, give or take...
[ Guests cannot view attachments ]
In situ ready to put some pressure on the, well that part that never goes over the carb to easily.
[ Guests cannot view attachments ]
Wrench to apply the pressure.
[ Guests cannot view attachments ]
So, one hand on the wrench one on the screwdriver and I was pleased
Today I made a tool out of wood and fitted the box very quickly.
Here are a few photos of what I made.
Oval shape, using the metal link part that goes into the airbox as a pattern.
[ Guests cannot view attachments ]
It is one and a half inch thick, give or take...
[ Guests cannot view attachments ]
In situ ready to put some pressure on the, well that part that never goes over the carb to easily.
[ Guests cannot view attachments ]
Wrench to apply the pressure.
[ Guests cannot view attachments ]
So, one hand on the wrench one on the screwdriver and I was pleased